Advertisement
Available languages
Available languages
tmitbieshoofing^iie
Often, what appears to be a malfunction is due to user error. Before calling for service,
please consult the following table.
Symptom
Cause
Remedy
No sound.
(No sound from one side.)
Input (or output) cables are.
disconnected.
Connect the input
Cor output) cables.
The output level is too
small (or too large).
The input sensitivity adjusting
control Is not set to the correct
position.
Adjust the control correctly
referring to 'Controls".
The sound quality is bad.
(The sound is distorted.)
The speakers cable are
connected with wrong @/©
polarity'.
Connect them properly checking
the ©/© of the terminals and
cables well.
A speaker cable is pinched by a
screw in the car body.
Connect the speaker cable again
so that it is not pinched by
anything.
Specifications
Specifications subject to change without notice.
Audio Section
Max Power Output (4 Q)
Normal.
Bridge.
Rated Power Output (4 Q)
Normal.
Bridge.
Rated Power Output (2 O)
Normal.....
Frequency Response..
Signal to Noise Ratio..
Sensitivity (MAX)..
Sensitivity (MIN).
Input Impedance...
.70 W X 2
.200 W
X
1
.35 W X 2 (20 Hz ~ 20 kHz, less than 0.08 %THD)
..lOOWxl (1 kHz, 0.8%THD)
.50 Wx 2 (1 kHz, 0.8 % THD)
.10Hz~45 kHz(+0, -1 dB)
.100 dB
.0.15 V (rated output)
.4.0 V (rated output)
.10 kil
General
Operating Voltage ........14.4 V (11 - 16 V allowable)
Current Consumption (1 kHz, 10% THD) .i.15 A
Dimensions (W x H x D}.220 x 52 x 160 mm
(8-11/16x2-1/16 X 6-5/16 in.)
Weight.....1-6 kg (3.5 lb)
8 English
Advertisement
