Table of Contents
Advertisement
B
Below is a list of frequently occurred symptoms for the DVD. Before you call for service, make
these simple checks. Some of these symptoms can easily be rectified if you know what to do.
Symptom
No power
No picture
Completely distorted
picture or no colour
with player menu
Distorted or Black/White
picture with DVD or Video
CD
Distorted sound from HiFi
ampliflier
No audio at digital output
Disc cannot be played
No return to start-up
screen when disc is
removed
Player does not respond
to the remote control
Buttons do not work
Player does not respond
to all operating commands
during playback
C
EFORE
ALLING
What you should do
• Check if both plugs of the power cord are properly
connected.
• Check if there is power at the AC outlet by plugging in
another appliance.
• Check if the TV is switched on.
• Check the video connection.
• If the picture is distorted completely or if the picture rolls
vertically, make sure the NTSC/PAL setting at the DVD
player matches the video signal of your television.
If your TV video signal is NTSC, select NTSC setting at
the DVD player. If your video signal is PAL, select the PAL
setting (Refer to section on "Selecting the Colour/Sound
System).
• The disc format does not match your TV's video signal
(PAL/NTSC).
• Check to make sure that no audio connections are made to
the amplifilier phono input.
• Check the digital connections.
• Check the settings menu to make sure the digital output is
set to ALL or PCM.
• Check if the audio format of the selected audio language
matches your receiver capabilities.
• Ensure the disc label is facing up.
• Clean the disc. Wipe the disc from the center out. Note : Do
not use solvents such as benzine, thinner, commercially
available cleaners or anti-static spray intended for analog discs.
• Check if the disc is defective by trying another disc.
• Check to see if the disc is badly scratched or warped.
• Reset by switching the player off, then, on again.
• Check to see if the program requires another disc to be
loaded.
• Aim remote control directly at the sensor on the front of
the player.
• Remove any obstacles between the player and the remote
control.
• Inspect or replace the batteeries in the remote control.
• Set the player in standby by using the STANDBY button on
the front of the player. Press STANDBY button again to set
the player back to ON.
• Operations are not permitted by the disc. Refer to the
instructions of the disc.
S
(DVD))
ERVICE
5
Advertisement
Table of Contents
