Advertisement
point A during A-B (INTERVAL)
REPEAT operation.
TROUBLESHOOTING
SYMPTOM
CAUSE
REMEDY
13. Certain discs take too long to | @ There are errors when the disc code is | @
Press Mi or
M/4 and stop the playback. Press
start or do not start.
read (There is no damage to the unit).
the ® or m/il
and start the playback again.
(Repeat this operation a few times.)
14, The player takes too long to find | # Same as item 12 above.
@ Same as item 12 above.
{The repeat mode is cancelled).
15, Picture other than instructed is | @
searched
in TIME
NUMBER
SEARCH mode.
below:
{e.g.]
12-minute search
Method of inputting numerals in the TIME NUMBER
SEARCH
mode differs, depending on
whether time number is recorded on disc in minutes or minutes and seconds, as shown
@
Disc in which time number is recorded in minutes
CHP/TM
gg
"minutes"
@
Disc in which time number is recorded
PLAY/SEARCH
in minutes and seconds
CHP/TM
: |
i
oO
0
PLAY/SEARCH
J
"minutes"
"seconds"
WHEN PLAYING BACK A COMPACT DISC
—
SYMPTOM
CAUSE
REMEDY
Disc is loaded
upside dewn
(CD, COV,
onesided LD discs).
@
The playing surface of the discs is dirty.
16. Player stops
immediately
e
after playback is started.
@
Disc is not properly set on the disc table.
@
Load
the disc correctly with the label side
upward.
@
Use a soft cloth and lightly wipe off the dirt
from the surface of the disc. if necessary,
moisten a cloth with diluted neutral detergent
to remove heavy dirt or fingerprint.
@
Set the disc properly.
17. No sound output
@ The
stereo
amplifier
is not correctly
connected.
@
You are not operating the stereo amplifier
correctly.
@
The connection
terminals and/or the plugs
of the connection cords are dirty.
@
The
plugs of the connection
cords
are
disconnected, or are not fully pushed in.
@
The player is in pause mode.
@
Connect the amplifier correctly.
e@ Refer to the operating
instructions
for the
amplifier, and operate the amplifier correctly.
@
Clean the plugs and terminals and connect
again.
Make
sure
that connections
are
made
correctly.
e
Press > or »/H and restore the player to play
mode.
18. Sound is distorted.
@ The audio output jacks are connected to the
PHONO jacks.
@
The connection terminals and/or the plugs
of the connection cords are dirty.
@
The plugs of the connection cords are not
fully pushed in.
e@ Connect to the AUX, CD, VDP of LD jacks.
@
Clean the plugs and terminals and connect
again.
e@
Push the plug in firmly.
38
<VRB1048>
Advertisement
