Philips 28PW9617 Instruction Manual page 29

Camera & camcorder
Wired rear loudspeakers
Headphone
Connect Peripheral Equipment
28
1 2 3
REAR
Connect your camera or camcorder to sockets at the
right side of your TV.
Connect the equipment to
for mono equipment.
Press the key repeatedly to select the sound coming
from one or both loudspeakers of your TV.
For stereo equipment also connect
S-VHS quality with an S-VHS camcorder is obtained by
connecting the S-VHS cables with the
and inputs .
AUDIO
Warning: Do not connect cable
This may cause picture distortion !
When no wireless RF surround sound is possible or when
there is too much interference you can still enjoy Dolby
Pro Logic and Dolby Digital surround sound by connecting
the two rear loudspeakers to the TV with a stereo cinch
to stereo 3,5 mm jack cable.
Connect the (not supplied) cable with the
connector at the back of the active surround
(TV)
loudspeaker and with the black and red
outputs at the back of the TV.
Insert the plug into the headphone socket
side of the TV.
Press on the remote control to switch off the internal
loudspeakers of the TV.
The headphone impedance must be between 8 and 4000
Ohm. The headphone socket has a 3.5 mm jack.
In the menu select
SOUND
the headphone volume.
and
VIDEO AUDIO L
.
AUDIO R
input
S-VIDEO
and at the same time.
PRE-AMP IN
or
REAR R L
at the right
to adjust
Headphone volume