Kawai ES4 Owner's Manual page 4

Do not stand on the product or exert > PY @ Doing so may cause the product to become
excessive force. deformed or fali over, resulting in breakdown
or injury.
The product should be located so that its location or position does not interfere with its proper
ventilation. Ensure a minimum distance of 5cm around the product for sufficient ventilation.
Ensure that the ventilation is not impeded by covering the ventilation openings with items,
such as newspaper, table-cloths, curtains, etc.
Do not place naked flame sources, such as lighted candles on the product.
The product should be serviced by qualified service personnel when:
@ The power supply cord or the plug has been damaged.
@ Objects have fallen, or liquid has been spilled into the product.
@ The product has been exposed to rain.
@ The product does not appear to operate normally or exhibits a marked change in
performance.
@ The product has been dropped, or the enclosure damaged.
Notes on Repair
Should an abnormality occur in the proce immediately turn the power OFF, disconnect the
power cord plug, and then contact the shop from which the product was purchased.
CAUTION:
To prevent electric shock, match wide blade of plug to wide slot, fully insert.
ATTENTION:
Pour viier les chocs lectriques, introduire la lame la pius large de la fiche dans la borne
correspondante de la prise et pousser jusqu'au fond.
Instruction for AC power cord (U.K.)
Do not plug either terminal of the power cord to the ground of the AC outlet on the wall.
FCC Information
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
¥ Reorient or relocate the receiving antenna.
¥ Increase the separation between the equipment and receiver.
¥ Connect the equipment into an outlet on a different electrical circuit from the receiver.
¥ Consult the dealer or an experienced radio/TV technician for help.
Canadian Radio Interference Regulations
This instrument complies with the limits for a class B digital apparatus, pursuant to the Radio Interference
Regulations, C.R.C., c. 1374.