Preliminary Inspection; Power Connection - Yaesu FT-1000 Operating Manual

2. Station Installation - General Setup & AC Power
Preliminary Inspection
Inspect the transceiver thoroughly immediately
upon opening the packing carton. Check to see that all
controls and switches work freely, and inspect the cab-
inet for any signs of damage. Make sure the accessory
fuses and plugs pictured on page 3 are included. If any
damage is found document it completely, and contact
the shipping company (or dealer, if you purchased it
over the counter) right away. Save the packing mat-
erials in case you need to return the set for service.
If you have purchased optional internal accessories
separately, install them as described in Chapter 6 (page
40).
Power Connection
The FT-1000 is designed for operation from AC
voltage only. Before connecting power, check the label
on the rear panel which indicates the AC mains voltage
for which your transceiver is currently set. If the volt-
age on this label does not match your AC mains volt-
age, the taps on the primary of the power transformer
in the transceiver must be rewired, and the fuse may
have to be changed. This requires only a screwdriver
and is not difficult (see below), but you should make
sure the transformer is wired correctly before connect-
ing power. If you have any doubts about the procedure,
contact your dealer for assistance.
CAUTION
Permanent damage will result if improper AC
supply voltage is applied to the transceiver.
your warranty does not cover damage caused
by application of improper supply voltage, or
use of an improper fuse.
We also recommend that you open the fuse holder
on the rear panel, and make sure that the fuse is correct
for your mains voltage:
AC Mains Voltage Fuse Capacity
100, 110 or 117 15A
200, 220 or 234 8A
After making certain the AC voltage for which the
transceiver is set matches your mains voltage, and that
the correct fuse is installed in the fuse holder, connect
the AC power cord to the 3-pin AC jack on the rear
panel. Wait until all other transceiver interconnections
have been made before connecting the other end of the
power cord to the wall outlet .
* Make certain that all cables are disconnected from
the transceiver.
* Replace the insulating sheets and their four screws,
and the top cover and its eight screws.
- p> _____ oA L0V.
100V
- net
ad ——e o2
- od - = . -~-c *%
TTL 1000
iS ea "SITE
ser re | "Tv
ACIOOV
ACLIOV
IMPORTANT!
If you change the primary transformer taps,
make sure to also change the voltage marking
on the label on the rear panel to match the new
Page 5