General Information - Specifications - Yaesu FT-1000 Operating Manual

I. General Information - Specifications
0 SSA $7 rete aS 6 SE ES
Specifications
General
Receiving frequency range: 100 kHz — 30 MHz
Transmitting frequency ranges:
160-m band, 1.5 to 2.0 MHz
80-m band, 3.5 to 4.0 MHz
40-m band, 7.0 to 7.5 MHz
30-m band, 10.0 to 10,5 MHz
20-m band, 14.0 to 14.5 MHz
17-m band, 18.0 to 18.5 MHz
15-m band, 21.0 to 21.5 MHz
12-m band, 24.5 to 25.0 MHz
LO-m band, 28.0 to 29.7 MHz
Frequency accuracy: < + 0.5 ppm at room temperature
Frequency stability: <+ 2 ppm from 0 to +50°C
(except FM, <+ 200 Hz),
<+0.5 ppm from -10 to +60°C w/TCXO-1 option
(FM <+ 150 Hz from 0 to +50°C)
Emission modes: LSB/USB (J3E), CW (A1A),
FSK (J1D, J2D), AM (A3B), FM (F3E)
Basic frequency steps:
10 Hz for J3E, AlA and J1D;
100 Hz for A3E, F3E and J2D
Antenna impedance: 16.5 to 150Q, 50Q nominal
Supply voltage:
100, 110, 117, 200, 220 or 234 VAC, 50/60 Hz
Power consumption (approx.):
95 VA receive, 1050 VA for 200 watts transmit
Dimensions (WHD): 420 x 150 x 375 mm
Weight (approx.): 25.5 kg. (51 lbs)
Transmitter
Power output:
adjustable up to 200 watts (50 watts AM carrier)
Duty cycle: 100% @ 100 watts,
50% @ 200 watts (FM & RTTY, 3-minute tx)
Modulation types
SSB: Balanced, filtered carrier
AM: Low-level (early stage)
FM: Variable reactance
FSK: Audio frequency shift keying
Maximum FM deviation: + 2.5 kHz
FSK shift frequencies: 170,425 and 850 Hz
Packet shift frequencies: 200, 1000 Hz
Harmonic radiation; at least 50 dB below peak output
SSB carrier suppresion:
at least 40 dB below peak output
Undesired sideband suppresion:
at least 50 dB below peak output
Audio response (SSB):
not more than —6 dB from 400 to 2600 Hz
page 2
3rd-order IMD: —36 dB @ 150 watts PEP,
~—31 dB @ 200 watts PEP, or better
Microphone impedance: 500 to 600 Q
Receiver
Circuit type:
quad-conversion superheterodyne
(triple conversion for FM)
Intermediate frequencies:
73.62 and 8.215 MHz, and 455 and 100 kHz
Sensitivity:
(With preamp on, for 10 dB S/N, 0 dBu = 1 pV)
Frequency => 250-500 | 05-18 | 18-30
Mode (BW) kHz MHz MHz
oe eee
29-MHz FM
(for 12 dB SINAD}
Selectivity (-6/-60 dB):
Dynamic range (typical):
108 dB (@50 kHz, 500-Hz BW, RF amp off)
Squelch sensitivity:
1.8 — 30 MHz (CW, SSB, AM): < 2.0 pV
28 — 30 MHz (FM): <0.32 LV
IF rejection (1.8 — 30 MHz):
80 dB or better
Image rejection (1.8 — 30 MHz):
80 dB or better
IF shift range: +1.12 kHz
Maximum audio power output:
2 watts into 4Q with <10% THD
Audio output impedance: 4 to 80
Specifications are subject to change, in the inter-
est of technical improvement, without notice or
obligation.