5. Glue Adjustment Screw for 1st A Lens Frame Unit with "Three Bond 1401B or 1401C".
Note: The glue does not come out above Adjustment Screw.
6. Insert 1st Lens Frame Shaft using a nipper with a fine tip since the shaft is small.
7. Install 3 1st Lens Frame Springs.
8. Tighten 3 screws (F) in numerical order by using the torque driver with specified torque.
③
① → ② → ③
Screw Order
Torque
8.0 ± 1.0 N ・cm
1st Lens Frame Shaft
①
1st Lens Frame Spring
Screw (F) x 3
②
6
BLACK
Screw (F)
18