Pioneer RX-310 Operating Instructions Manual page 7

PANEL FACILITIES
TUNER SECTION
@STATION CALL switches
(BAND selector switch (FM/AM)
This is used to select the band of the desired station. The
These are used to recall preset broadcasting stations and to
preset the station.
(@) FREQUENCY (STATION NUMBER) DISPLAY
@ INDICATORS
[TUNED]
This lights to indicate that a station has been optimally tuned
in.
[STEREO]
This lights during FM'stereo reception.
{FM MONO]
Lights when the FM MONO switch is pressed to select
monaural FM reception.
{AUTO TUNING]
Lights when the auto tuning mode is selected during FM/AM
reception.
@) MEMORY switch
This switch is used to memorize stations. When the switch
is pressed, the FREQUENCY indicator will flash. To memorize
the frequency of any station, press the STATION CALL switch
while the frequency indicator is flashing.
G)FM MONO switch
Normally, the FM MONO indicator remains off. However, it
may not be possible to tune in a desired FM station because
it is too far away or because its signals are too weak. In cases
like these, press the switch to set the reception to the mon-
aural mode (FM MONO indicator lights) and tune in the station.
The program of an FM stereo broadcast will be heard in mono.
This switch will not function for AM reception.
(®AUTO/MANUAL switch
Use to select either the AUTO mode or MANUAL mode for
FM/AM reception.
@TUNING switch
The function of this switch differs according to whether AUTO
tuning or MANUAL tuning is Selected.
{AUTO tuning mode]
When this mode is selected, AUTO TUNING indicator lights
(press AUTO/MANUAL switch if the indication'is not lighting}.
When the "+" side is pressed, the frequencies are scanned in
ascending order; when the "—" side is pressed, they are
scanned in descending order. Scanning stops as soon as a
station has automatically been tuned in.
Auto scanning is terminated when either TUNING, AUTO/
MANUAL, BAND or MEMORY swich is pressed.
[MANUAL tuning mode]
When the "+" side is kept pressed, the frequency increases
and when the "—" side is kept pressed, it decreases.
bands change aiternately each time the switch is pressed.
L
@ POWER (STANDBY/ON) switch
When this switch is set to the ON position, the STAND-
BY/SLEEP indicator goes out and power is supplied to the main
circuits of the cassette deck receiver.
Disconnect the power cord from the power outlet when you
do not plan to use the cassette deck receiver for a long period
of time.
40 STANDBY/SLEEP indicator
(DPHONES jack
| NOTE:
(3 GRAPHIC EQUALIZER controls
The equalizer is divided into five frequency ranges (100 Hz, 330 Hz,
1 kHz, 3.3 kHz, 10 kHz) to adjust music to the individual taste of
the listener.
NOTE:
Effective only for audio playback. Does not work far recording
H and copying operations.
we:
<ARB1145>