Belkin RT3200 User Manual page 13

2.4GHz Network Mode---- - Select the wireless standards your network will support.
• Mixed (default)
Keep the default if you have Wireless-B, Wireless-G, Wireless-N 2.4GHz devices in your
network.
• Wireless-B/G Only
Select if you have Wireless-B, Wireless-G devices in your network.
Wireless-B Only
•
Select if you have only Wireless-B devices.
Wireless-G Only
•
Select if you have only Wireless-G devices.
Wireless-N Only
•
Select if you have only Wireless-N 2.4G devices.
• Disabled
Select if you have no Wireless-B, Wireless-G, and Wireless-N (2.4 GHz) devices in your
network. 2.4GHz radio will be off after you choose this option.
Note—If you are not sure which mode to select, keep the default, Mixed.
Network Name (SSID)
The Service Set Identifier (SSID) is a name used by devices to connect to a wireless network. SSIDs
are case-sensitive and must not exceed 32 characters. The default SSIDs for the 2.4 GHz and 5 GHz
networks are BelkinXXXXX and BelkinXXXXX_5GHz, respectively. The Xs represent the last five
digits of the router's serial number, which can be found on the bottom of the router. If you changed
the SSID, both bands have the new SSIDs. You may give them different names through the browser-
based utility.
Note—If you restore the router's factory default settings (by pressing the Reset button or
using the Configuration > Administration > Device Reset screen), the Network Name will
return to its default value. Change the Network Name back to its original name, or you will
have to reconnect all devices on your wireless network to the new network name.
Channel Width
Keep the default, Auto (20 MHz or 40 MHz), for best performance in a 2.4 GHz network using
Wireless-B, Wireless-G and Wireless-N (2.4 GHz) devices. For a channel width of 20 MHz, select 20
MHz only. For the best performance in a 5 GHz network, keep the default Auto (20, 40 or 80 MHz).
Channel
Select the channel from the drop-down list. Keep the default, Auto, if you are not sure which channel
to select.
13