Advertisement
TABLE OF CONTENTS
Thanks for Choosing TOTO
! ........................................................................................... 3
®
Before Installation ............................................................................................................... 3
Included Parts ..................................................................................................................... 4
Warnings.............................................................................................................................. 4
Installation Procedure ........................................................................................................ 3
Warranty .............................................................................................................................. 7
THANKS FOR CHOOSING TOTO!
The mission of TOTO is to provide the world with healthy, hygienic and more
comfortable lifestyles. We design every product with the balance of form and function
as a guiding principle. Congratulations on your choice.
WARNINGS
When this symbol appears in the manual, it is alerting you of potential
misoperations that may cause personal injury and/or property damage.
WARNING
BEFORE INSTALLATION
If you are installing this product in a new construction or remodel, please make sure
you are following all local plumbing and building codes. Carefully unpack and examine
your new fixture for damage. To help ensure that the installation process will proceed
smoothly and correctly, please read these instructions carefully before you begin.
„ Provide proper reinforcement, such as a brace, between the studs of the wall to
help support the lavatory.
„ Install the brace at the proper height (H), which corresponds to the bracket and
lavatory mounting hole locations.
„ For best results, the floor must be level and the wall must be square with the floor.
Bracket
Existing Wall
Stud
Reinforcement
Mounting Hole Location
H
2
Before Installation (continued)
„ Refer to the rough-in guide for the location of the mounting bracket holes.
„ Use a pencil to mark the location of the screw hole that corresponds to the slotted
hole in the mounting bracket.
„ Drill a pilot hole for the wood screw.
„ Install the mounting plate to the wall using the bottom screw only.
INSTALLATION PROCEDURE
1) Place the lavatory on the bracket and brace it ad-
equately so that the lavatory cannot tip over. Check
to make sure that the lavatory is installed at the cor-
rect height and is level, then mark the location of the
mounting holes in the lavatory (see Illustration 1).
N OTE: To help recall the lavatory position, trace a
line along the sides and top edge of the lavatory
with a pencil.
Remove the lavatory from the bracket. Drill the
remaining holes for the mounting bracket and install
the two remaining screws.
2) Install the faucets and drain (not supplied) per the
manufacturer's installation instructions.
3) Return the lavatory into position with the marks on
the wall. Install the lavatory mounting hardware (see
Illustration 2). Place a metal washer onto a screw.
Insert the screw through a mounting hole in the lava-
tory.
NOTE: Do not secure the screw at this time.
Place the remaining metal washer onto the screw.
Insert the screw through the remaining mounting
hole in the lavatory. Level the lavatory with the mark
along the top and sides of the lavatory. Secure the
lavatory to the wall.
DO NOT OVERTIGHTEN. Overtightening
may damage the products and cause per-
WARNING
sonal injury and/or property damage.
4) Connect the water supply to the faucet according to the faucet instructions. Connect
and tighten the trap to the drain. Turn on the water supplies to the faucet. Purge air
from the hot and cold water by running the water for a few seconds. Fill the lavatory
with water. Check for any leaks at the water supply and drain connections.
Ill. 1
Ill. 2
3
Advertisement
