Table of Contents
Advertisement
bre dub the sound
from an audio system
To dub the sound
from a microphone
You can additionally record music or narration on the
prerecorded tape while watching the playback picture of
the tape. Audio dubbed sound will be recorded on the
PCM track.
Connection eI
Notes on connection
© If only one microphone is used, connect it to the MIC L
jack. The sound from the L jack is recorded on the right
and left channels of the PCM track while the sound from
the R jack is recorded on the right channel! only.
© To dub the sound from the audio system, disconnect the
microphone from the MIC L/R jacks.
¢ A plug-in-power microphone cannot be used with this
unit.
Operation (Hi:
Before operation
* PCM MODE switch: NORM
¢ AUDIO MONITOR selector: PCM or MIX
* Turn on the TV and select the input for the VCR or
select the channel for the VCR.
4 Press INPUT SELECT so that the LINE indicator
appears.
When dubbing the sound from the audio system,
select LINE 1 or 2.
2 Play back the tape to locate the point where
audio dubbing should start and press #1 PAUSE.
3 Press AUDIO DUB.
The AUDIO DUB indicator on the VCR will light.
4 Play back the audio source and adjust REC
LEVEL.
5 Press s1 PAUSE again to release playback
pause mode.
Audio dubbing will start.
To stop audio dubbing momentarily
Press §1 PAUSE.
To stop audio dubbing
Press m@ STOP.
To dub the sound of a TV program
Press INPUT SELECT to display the TUNER indicator and
select the desired channel. Proceed with steps 2 to 5.
Notes
* During dubbing, a black band or picture noise appears in
the center and lower portions of the screen, but the
recorded picture will not be affected.
* The audio signals prerecorded on the PCM track and
index signals wil! be erased after completion of audio
dubbing.
¢ The audio dubbed sound cannot be played back on a
VGR without the PCM recording/playback function or a
video camera recorder.
Advertisement
Table of Contents
