Download Print this page

Panasonic SC-DK2 Operating Instructions Manual page 38

Dvd stereo system

Advertisement

The
indicator
i
RQT5327
SHIFT--
Play a DVD encoded
with Dolby Digital.
The nnDIGITAL
indicator lights.
Subwoofer
You can enhance
the surround sound by connecting another
subwoofer (-, page 52 for connection).
If you connect a subwoofer:
Press and hold {S.WOOFER]
on the main unit until "SUB W ON" is
displayed.
If you disconnect the subwcofer:
Press and hold [S.WOOFER] on the main unit until _SUB W OFF" is
displayed.
[]
To down-mix
Dolby Digital
(5.1 ch) signals
to 2
channels
Remote control only
Press [SHIFT] + [MIX 2CH].
To cancel, press [SHIFT] + [MIX 2CH].
]
Speaker level adjustments
I
If the level of the speakers appears to be different while listening to a
source, adjust the level of the speakers to the same apparent level.
Sit in the normal listening position and make the adjustments
with
the remote control.
Remote control only
Preparation:
Turn other surround systems off.
(_ Press [SHIFT] + [TEST] to output a test signal.
A test signal is output from the speakers in the following order•
Lch:
Front left speaker
Cch:
Center speaker
Rch:
Front right speaker
RSch:
Right surround speaker
LSch:
Left surround speaker
The speaker's indicator
flashes while the speaker is outputting
the test signal.
No signal is output for the subwcofer.
_) Press [VOLUME
(- or +)] to set the volume level of the front
speakers normally used for enjoying the source.
(_) While the speaker to be adjusted is outputting a signal
Press the cursor
buttons
[A]
(to increase
level) or IV]
(to
decrease level) to adjust the level of each speaker.
Lch, Rch: -16 dB to OdB
Cch, RSch, LSch: -10 dB to +6 dB
Repeat step (_) to adjust the level accordingly.
To stop the test noise
Press [SHIFT] + [TEST] again.
To select a specific speaker
t. Press [SHIFT] + [CH SELECTJto select the speaker.
Each time youpressthe buttons:
Lch * Cch ÷ Rch _ RSch_ LSch_ SWch
t
J
SWch:
Subwcofer
(Adjust only when connected)
2. While the speaker's indicator is flashing
Press the cursor buttons [&] or [V] to adjust the level.

Advertisement

loading