Connecting Peripheral Equipment - Philips 21PT5322 - annexe 1 Handbook

Connecting peripheral equipment

The socket has audio and video inputs/outputs and RGB inputs.
EXT1
The socket has audio and video inputs/outputs and S-VHS inputs.
EXT2
For further information, see glossary (p. 18).
Video recorder
• If your video recorder has a euroconnector socket, carry out the above
connections. Euroconnector sockets ensure better picture quality.
• If your video recorder does not have a euroconnector socket (or if this is
already being used by another device), then the only connection possible is via
the aerial cable.Your video recorder is then considered as a TV programme by
your TV set.You will therefore need to tune in your video recorder's test signal
and assign it programme number 0 (see manual store chapter, p. 5).
To reproduce the video recorder picture, press the
Refer to your video recorder's operating instructions concerning the test signal
(the video recorder must be equipped with an HF modulator).
Connecting other equipment
(satellite receiver, decoder, CDV/CDI, games...)
Connect to socket
To select connected equipment
• Use key to select
Most equipment (decoder, video recorder) carries out the switchover itself.
• The white key may also be used to select the sockets with adapted Smart
Controls:
E1 DIGITAL
(for games connected to
the socket on the front panel).
VIDEO
(or to if it produces a
EXT1 EXT2
,
E1 (EXT1) E2 (EXT2)
(for digital equipment connected to
) and
EXT1 E2 GAMES FRONT
...with Decoder
key.
signals).
S-VHS
or, for S-VHS or Hi-8 equipment,
EXT1
(for games connected to
.
E2 Y/C
),
E1 GAMES BACK
15