Table of Contents
Advertisement
Removing the door cover
The stainless steel inlay in the door cover may become
discoloured. To carry out thorough cleaning, you can
remove the cover.
Open the appliance door slightly.
1.
Press on the right and left side of the cover (figure
2.
).
!
Remove the cover (figure
3.
Close the appliance door carefully.
Clean the stainless steel inlay in the cover with
Note:
stainless steel cleaner. Clean the rest of the door
cover with soapy water and a soft cloth.
Open the appliance door again slightly. Put the
4.
cover back in place and press on it until it clicks
audibly into place (figure
Close the appliance door.
5.
Removing and installing the door panels
To facilitate cleaning, you can remove the glass panels
from the appliance door.
:
Warning
Risk of injury!
Scratched glass in the appliance door may develop
■
into a crack. Do not use a glass scraper, sharp or
abrasive cleaning aids or detergents.
The hinges on the appliance door move when
Risk of injury!
■
opening and closing the door, and you may be
trapped. Keep your hands away from the hinges.
Components inside the appliance door may have
Risk of injury!
■
sharp edges. Wear protective gloves.
).
"
).
#
Removing the door from the appliance
Open the appliance door slightly.
1.
Press on the right and left side of the cover (figure
2.
).
!
Remove the cover (figure
3.
Loosen and remove the screws on the left and right
4.
of the appliance door (figure
Before closing the door again, trap a tea towel which
5.
has been folded several times in the door (figure
Pull out the front panel upwards and lay it on a flat
surface with the door handle facing downwards.
Clean the panels with glass cleaner and a soft cloth.
Fitting the door on the appliance
Insert the front panel at the bottom into the retainers
1.
(figure
).
!
Close the front panel until both upper hooks are
2.
opposite the opening (figure
Appliance door
).
"
).
#
).
"
en
).
$
35
Advertisement
Table of Contents
