Whirlpool 4GNTW4400 Use And Care Manual page 8

7, Select LOAD SiZE
MEDIUM
SMALL LARGE
EXTRA EXTRA
SMALL LARGE
LOAD S_ZE
Select the load size setting most suitable for your load. Extra
Small will add a low amount of water for smaller loads and
Extra Large will add the most amount of water for large or
bulky loads. Items need to move freely.
9. Select options
OFF
FABRIC
SOFTENER
WITH
EXTRA RINSE
Select the desired cycle options. If you are using fabric
softener, be sure to select one of the Fabric Softener options.
8, Select TEMPERATURE
COOL WARM
COLD HOT
Once you select a cycle, select the desired wash temperature
by turning the Temperature knob to the appropriate setting
based on your load. All rinses are tap cold.
NOTE: Always read and follow fabric care label instructions
to avoid damage to your garments.
Hot
Some cold water is added to save Whites and pastels
energy. This will be cooler than Durable garments
your hot water heater setting. Heavy soils
Warm
Some cold water will be added, so Bright colors
this will be cooler than what your Moderate to light soils
Cool
Warm water may be added to
assist in soil removal and to help
dissolve detergents.
Colors that bleed
or fade
Cold
This is the temperature from your Dark colors that
faucet. If your tap cold water is bleed or fade
very cold, warm water may be Light soils
added to assist in soil removal and
help dissolve detergent.
Press START/Pause/Unlock Lid
to begin wash cycle
_>
START
PAUSE/
UNLOCK LID
©
CANCEL HOLD 3 SEC
Press the START/Pause/Unlock Lid button to start the wash
cycle. When the cycle has finished, the Cycle Complete
indicator will light. Promptly remove garments after cycle has
completed to avoid odor, reduce wrinkling, and rusting of
metal hooks, zippers, and snaps.
Unlocking the lid to add garments
If you need to open the lid to add 1 or 2 missed garments:
Press START/Pause/Unlock Lid; the lid will unlock once the
washer movement has stopped. This may take several
minutes if the load was spinning at high speed. Then close lid
and press START/Pause/Unlock Lid again to restart the cycle.
If lid is left open for more than 10 minutes, the water will pump
out automatically.
8