Technics SA-AX910 Operating Instructions Manual page 19

Enjoying sound with DOLBY PRO LOGIC
by remote control only
Press TEST to output a test signal.
The speaker outputting the test signal is displayed while the
test is running.
L : Front speaker (left)
C : Center speaker
R : Front speaker (right)
S: Surround speakers
For SURROUND mode
L-C-R-S
t_l
For 3 STEREO mode
L-C-R
4
M
by remote control
Press VOLUME (+) or (-) to set the volume level
normally used for enjoying the source.
The following steps are for setting the output level of the
front speakers and the center/surround speakers to the same
listening level.
5 B by remote control only
Press CH SELECT to select the center or surround
speakers.
0 J by remote control only
Press or to adjust the output level.
Decrease the output level.
+: Increase the output level.
Output level can be varied within a range of -12 dB to +12 dB
with front speaker output level serving as the zero point.
IEEIE1
1. The test signal is output only by the speaker you are now
adjusting and does not repeat the sequence until
adjustments are complete.
2. Remember you cannot adjust output level of the surround
speakers if you selected the 3 stereo mode in step 1.
To stop the test signal
Press TEST.
To turn off the Dolby Pro Logic systems
Press OFF/ON
Press once again to turn it on.