Table of Contents
Advertisement
To operate the product
1. Set the throttle control in the operation position.
2. Hold the handle and move the product in the
necessary direction.
CAUTION:
down. Too much pressure can cause
unsatisfactory result.
3. Make sure that the rammer shoe is parallel to the
ground during the operation.
Introduction
WARNING:
safety chapter before you do maintenance
on the product.
General product maintenance
Make sure that there are no fuel or oil leaks.
Clean the product.
Make sure that nuts and screws are tightened.
Examine the throttle control for damage.
Make sure that the throttle control can move smoothly.
Lubricate the throttle control and the engine throttle wire.
Do a check of the oil level in the rammer leg.
1167 - 004 - 12.09.2023
Do not push the product
Maintenance
Read and understand the
To stop the product
1. Set the throttle control in the idle speed position. Let
the engine operate at idle speed for 2–3 minutes.
2. Set the throttle control in the stop position.
Maintenance schedule
* = General maintenance done by the operator. The
instructions are not given in this operator's manual.
X = The instructions are given in this operator's manual.
O = Refer to the engine manual for instructions.
Before use,
After the
each 10 h
first 20 h
*
X
*
*
*
X
X
Weekly,
Yearly, each
each 100 h
500 h
X
X
9
Advertisement
Chapters
Table of Contents
