Table of Contents
Advertisement
FRONT
PANEL
FACILITIES
POWER
SWITCH
Set to ON position to energize SA-5500II. After setting to
ON, there is a brief delay before sound is obtained. This
is due to the operation
of the muting circuit which
prevents noise when the POWER
is switched. This func-
tion does not indicate difficulty and normal operating
condition is attained in a few seconds.
BASS AND
TREBLE
CONTROLS
Controls for adjusting low and high frequency tone. Turn
controls clockwise to enhance low or high frequencies and
counterclockwise to attenuate their respective frequency
ranges.
PILOT LAMP
PHONES
JACK
When listening with stereo headphones, connect them to
this jack.
NOTE:
Set SPEAKERS
buttons
to OFF
(released
position)
when listening only with headphones.
SPEAKERS
BUTTONS
Switch for selecting speaker systems connected to the rear
panel.
Seund
from
corresponding
speaker
systems
is
obtained
when
button
is depressed, while sound is not
obtained in the released position.
A:
Sound
obtained:
from
speakers
connected
to the
A speakers terminals.
B:
Sound
obtained
from
speakers
connected
to the
B speakers terminals.
If both buttons are depressed simultaneously, sound will
be obtained from both sets of speaker systems.
When listening with headphones, set SPEAKERS buttons
to released (OFF) positions.
BALANCE
CONTROL
Adjusts relative left and right channel volume balance
between
speaker systems and headphones.
If the right
channel volume is insufficient, turn the control clockwise
from
center. Conversely,
if the left channel volume
is
insufficient,
turn
the
control
counter-clockwise
from
center.
VOLUME
CONTROL
Adjusts volume from speakers and headphones. Clockwise
rotation increases volume.
W PIONGER
STEREO
AMPLIFIER SA 5001
FUNCTION
SWITCH
Selects desired playback program source.
PHONO:
To play records on a turntable connected to the
PHONO jacks.
TUNER:
To listen to broadcasts with a tuner connected
to the
TUNER Jacks.
AUX:
To play a component connected to the AUX
jacks.
LOUDNESS
SWITCH
When listening at low volume settings, set switch to ON to
enhance low frequencies. The response of the human ear
to sound differs according to loudness. This switch com-
pensates for this effect at low volumes.
TAPE
MONITOR
SWITCH
Set to ON to play on a tape deck connected to the TAPE
jacks or to monitor recording conditions.
NOTE:
Be
sure
to set switch
to
upper
(OFF)
position
when
.
playing records or listening to broadcasts.
Advertisement
Table of Contents
