Setup; Basic Configuration - Buffalo AirStation NFINITI HighPower WZR-600DHP User Manual

Router and access point professional firmware
Hide thumbs Also See for AirStation NFINITI HighPower WZR-600DHP:
Table of Contents

Advertisement

2.3.1.

Setup

2.3.1.1.

Basic Configuration

Setup Information
The SSID, wireless passphrase, IP address, username, and password that
were set for the AirStation are displayed.
Clicking Run Initial Setup Wizard opens the "Setup Assistant" screen.
Follow the on-screen instructions to make the initial settings for the
AirStation.
Clicking Print Setup Card will print out the information displayed on
this screen.
If multiple SSIDs for guests are set, clicking Print Guest Card will
print out the encryption key for each SSID that is set in the
AirStation.
The information (SSID, wireless passphrase, username, password)
displayed in the Setup Card Information area can be edited directly by
simply clicking the desired information. After making any changes, be
sure to click Apply Changes to apply the new settings to the
AirStation.
WAN Setup
Here you'll find the most important settings to configure your
Internet access and WAN port. DHCP is enabled by default, but you can
also use PPPoE, PPTP, L2TP, static IP, or HeartBeat Signal. If you
don't use a password to log in to your ISP, you may need to enter
"0000" for the password. Also, for some ISPs you should not enter the
service name, as it will prevent establishing the connection. If you
experience connection problems, then leave the service name empty.
WAN Connection Type
Disabled
Static IP
Automatic
Configuration - DHCP
PPPoE
PPTP
L2TP
HeartBeat Signal
3G/UMTS
Description
The WAN port is disabled.
A static IP address will be used – enter the
IP address, subnet mask, gateway, and server
manually.
The router obtains its WAN-side IP address
from a DHCP server.
Configure as PPPoE-client.
Establishes connection via PPTP.
Establishes connection via L2TP.
If you use a HeartBeat connection, consult
your ISP for setup information.
Signal is used only in Australia.
Configures Internet Access via 3G/UMTS.
Enable USB in the "Services" section and
attach a 3g/UMTS USB stick to the router.
This setting is available in AirStations sold
in the European region only.
- 6 -
HeartBeat

Advertisement

Table of Contents
loading

Table of Contents