Table of Contents
Advertisement
IMPORTANT
The lightning flash with arrowhead, within an equi-
lateral tangle, 1s intended to alert the user of the
presence of uninsulated "dangerous voltage" within
the product's enclosure that may be of sufficient
magnitude 10 constitute a tisk of electric shock to
persons.
CAUTION
RISK OF ELECTRIC SHOCK
:
DO. NOT OPEN
CAUTION:
TO PREVENT
THE RISK OF ELECTRIC SHOCK,
DO
NOT
REMOVE
COVER
(OR
BACK}.
NO
USER-SERVICEABLE
PARTS
INSIDE.
REFER
SERVICING
TO
QUALIFIED
SERVICE
PERSONNEL.
The exclamation point within an equilateral tangle s
intended to alert the user of the presence of important
operating and maintenance (servicing) instructions in
the literature accompanying the apphance
READ
INSTRUCTIONS — ait the safety
and
operating instructions should be read betore the
appliance ss operated.
RETAIN INSTRUCTIONS — The operating instruc-
tions shauld be retained for future reference
HEED WARNING — All warnings on the apphance
and in the operating instructions should be
adhered to.
FOLLOW INSTRUCTIONS — Aff operating and use
POWER LINES — An outdoor antenna shauld be
located away from power lines.
NONUSE
PERIODS —The power cord of the
appliance should be unplugged from the outlet
when left unused for a long period of time
OBJECT AND LIQUID ENTRY — Care should be
taken so that objects do not fall and iiquids are
not sptiled into the enclosure through openings
DAMAGE REQUIRING SERVICE — The appliance
should be serviced by a Pioneer authonzed sex
vice center or qualified service persannel when:
instructions should be followed
WATER
ANO
MOISTURE
-~
The appliance should
bathtub, washbow!, kitchen sink, laundry tub, in a
damaged: ot
VENTILATION — The appliance should be situated
mance, of
$0 that its location of position does not interfere
©
The apphance has been cropped; ar the enclosure
with it proper ventilation Far example, the ap-
damaged
SERVICING
— The user should aot attempt to
service the appliance beyond that described in the
Operating instructions For all other servicing,
contact
the nearest
Pioneer
authonzed
service
center
lance should not be situated on a bed, sofa, rug,
or similar surface that may block the ventilation
'openings; or, placed in a built-in instalation, such
as 4 bookcase
or cabinet
that may
impede
the
flow of ait through the ventilation openings.
HEAT -- The apptiance should be situated away from
heat sources such as radiators, heat registers,
ves, oF other appliances (including amplifiers}
that produce heat.
POWER
SOURCES ~ The
appliance
should
be
connected to a power supply only of the type
described
in the operating
instructions
or as
marked on the appliance
POWER-CORD
= PROTECTION
— Power-supply
cords should be outed so that they are not likely
to he walked on or pinched by items placed upon
oF against them, paying particular attention ta
cords at plugs. convenience receptacles, and the
paint where they exit from the appltance
POLARIZATION ~~ if your purchased product is
provided with 3 polatized power plug, please read
the
following
instructions.
This
product
is
-
equipped with a polarized alternating current tine
plug (a plug having one biade wider than the
other) This plug will fit into the power outlet only
one way. This 1s a safety feature {f you are unable
to insert the plug fully into the outlet, try reversing
the plug Hf the piug should still fail to fit. contact
your electrician to replace your obsolete outlet
Do not deteat the safety purpose of the polanzed
plug
POWER SERVICE
Fy
GROUNG
GROUND WIRE 3b
SERVICE ENTRANCE
CLAMPS:
EQUIPMENT
eS
clames
GD
GROUND
OUTDOOR ANTENNA GROUNDING — if an our-
side antenna 1s connected to the antenna tetmi-
nal, be sure the anterina system 1s grounded so as
to provide some protection against voltage surges.
and built up static charges.
In the USA. section 810 of the National Elec-
tical Code, ANSI/NFPA No, 70-1984, provides
information wath respect to proper grounding of
the mast and supporting structure, grounding of
the lead-in wire to an antenna discharge unit, size
of grounding conductors, focation of antenna-
discharge unt, connection to grounding eiec:
trodes and requirements for the grounding eiec-
trode See Fig A
a) Use No. 10 AWG (5 3mm?) cop-
pet, No 8 AWG (8.4 mm?) aly.
minum, No 17 AWG (1.0 mm*)
copperciad steel, bronze wire, or
larger as ground wire
b)
Secure
antenna
fead-in
and
ground
wires
to house
with
Stand-off insulators spaced
from
4 feet {1.22 meters) to 6 feet
(1.83 meters} apart
c}
Mount antenna discharge unit as.
closely as possible to where lead-
an enters house
Use jumper ware mot smaiter than:
No 6 AWG (133 mm') capper.
or the equivaient, when a sepa-
rate antenna-grounding electrode
4s used.
See NEC Section 810-21 (4)
STANDOFF
gy
INSULATORS &
ANTENNA,
LEAD. IN WIRE
TQ EXTERNAL ANTENNA
TERMINALS OF BRGOUCT
ANTENNA
DISCHARGE
UNIT ¢
GROUND
WARE ab
OPTIONAL ANTENNA
GROUNDING ELECTRODE
ORIVEN 8 FEET (2.44 my
INTO THE EARTH
iF REQUIRED BY
LOCAL CObES See
NEC SECTION 810 21 (n
About the Demonstration Mode
2
<ARBIN5>
Advertisement
Table of Contents
