Table of Contents
Advertisement
Available languages
Available languages
How much detergent
to use
•
The amount of detergent to use depends on the soil level of
•
Water hardness can change over a period of time. Find out
your dishes, hardness of your water, and the type of
your water's hardness by asking your local water department,
detergent. If you use too little, dishes will not be clean. If you
water softener company, or county extension agent.
use too much in soft water, glassware will etch.
Detergent Dispenser fill recommendations
per dish load soil level and water hardness
Soft
(0-2 grains per
U.S. gallon)
Medium
(2-6 grains per
U.S. gallon)
Hard
(7 grains per U.S. gallon
and above)
Light Soil or Prerinsed
Normal - Heavy Soil
Water Hardness
Main Wash section
Pre-Wash section
Main Wash section
Pre-Wash section
4 tsp (20 mL)
Empty
6 tsp (30 mL)
2 tsp (10 mL)
Fill to Soft Water line
Fill above the Soft Water line
Fill to Soft Water line
6 tsp (30 mL)
2 tsp (10 mL)
6 tsp (30 mL)
4 tsp (20 mL)
Fill above the Soft Water line
Fill to Soft Water line
Fill above the Soft Water line
Fill to Hard Water line
8 tsp (40 mL)
Fill to Hard Water line
4 tsp (20 mL)
Fill to Hard Water line
9 tsp (45 mL)
Fill cup completely
7 tsp (35 mL)
Fill cup completely
NOTE: Fill amounts shown are for standard powdered detergent. Amounts may vary if you use liquid or concentrated
powdered
detergent. Tablet detergents should be placed in the main wash section of the detergent dispenser with the cover closed. Follow
instructions
on the package when using liquid dishwasher detergent, concentrated
powdered detergent or tablet detergent.
IMPORTANT:
Your dishwasher
is designed to use a liquid rinse aid. The use of rinse aids greatly improves drying by allowing water to
drain from the dishes after the final rinse. They also keep water from forming droplets that can dry as spots or streaks. Do not use a
solid or bar-type rinse aid.
4. Clean up any spilled rinse aid with a damp cloth.
Filling the dispenser
5. Place the knob back into the opening and turn to the "Lock"
position.
The rinse aid dispenser holds 5 oz (150 mL) of rinse aid. Under
normal conditions, this will last for about 1 to 3 months.
Rinse aid setting
1. Make sure the dishwasher door is fully open.
2. Turn the dispenser knob to "Open" and lift it out.
3=
A
.........
USERINSEAIDFOR
BETTER DRYING
Lock
iS
A. Dispenser knob
B. Indicator
C. Indicator window
Pour rinse aid into the opening until the indicator points to
"Full." Take care not to overfill. (When the rinse aid indicator
drops to the "Add" level, add more rinse aid.)
Full
Add
The amount of rinse aid released into the final rinse can be
adjusted. For most water conditions, the factory setting of 2 will
give good results. If you have hard water or notice rings or
calcium spots on your glasses or dishes, try a higher setting.
Lock
Open
To adjust the setting
1. Remove the dispenser knob.
2. Turn the arrow adjuster inside the dispenser to the desired
setting by either using your fingers or inserting a flat-blade
screwdriver into the center of the arrow and turning.
3. Replace the dispenser knob.
Advertisement
Table of Contents
