Table of Contents
Advertisement
STATUS LEDs
PRAC LOAD PAUSE SEND NORM
ON
ON
ON
* A pressed digit key(s) is "remembered" until you press a function key or
NORM LED dims to indicate this condition.
SUMMARY OF COMMANDS
1)
ON
2)
OFF
3)
n
LOAD <text> STOP
4)
n
LOAD <cmd string> STOP
5)
n
SEND
6)
SEND
7)
n
RPT
8)
RPT
9)
n
PRAC
10)
n
WPM
11)
n
SPC'G
12)
SPC'G
13)
n
WT
14)
WT
15)
TUNE
16)
P/C
17)
STOP
18)
P/C | STOP
19)
LOAD | SEND
NOTES:
1. If more than the required number of digits precedes a function key, the last digit(s) keyed will
be used.
2. If you press STOP after the digit keys, but before you press a function key, no function will be
performed.
3. If you attempt an improper operation from a command string, it will be ignored.
4. The repeat count set with the RPT key applies only to text buffers.
ON
(dim) Normal mode, digit(s) pressed*
ON
ON
ON
ON
ON
Turn keyer on
Turn keyer off
Clear buffer n and load with <text>
Load buffer n with <command string>
Send message n / execute command string n
Send message 0 / execute command string n
Set repeat count to n
Set repeat count to zero
Send code practice
Set character formation speed and spacing to n
Set spacing to n
Set spacing = formation speed
Set weighting to n
Set normal weighting
Latch output until other key or paddle is pressed
Pause / Continue sending
End current function
RESET keyer (keys pressed simultaneously)
Reverse paddles (keys pressed simultaneously)
- 11 -
Normal (power-up) mode
In "load text" or "load command" mode
Sending a message buffer
Paused while sending a message buffer
Paused from a command string
Sending code practice
Paused while sending code practice
STOP key. The
Advertisement
Table of Contents
