Electrolux EWT 1362HDS User Manual page 19

13.2 Possible failures
Problem
The programme does
not start.
The appliance does not
fill with water properly.
The appliance does not
fill with water and drain
immediately.
The appliance does not
drain the water.
Possible solution
Make sure that the mains plug is connected to the mains
socket.
Make sure that the appliance lid and drum doors are closed
properly.
Make sure that there is not a damaged fuse in the fuse
box.
Make sure that the Start/Pause has been pressed.
If the delay start is set, cancel the setting or wait for the
end of countdown.
Deactivate the Child Lock function if it is on.
Make sure that the water tap is open.
Make sure that the pressure of the water supply is not too
low. For this information, contact your local water authority.
Make sure that the water tap is not clogged.
This problem may be caused by the filter of the inlet hose
or the valve drain filter which may be clogged. Refer to
"Care and cleaning". If problem remains please contact the
Authorised Service Centre.
Make sure that the inlet hose has no kinks or bends.
Make sure that the connection of the water inlet hose is
correct.
Make sure that the drain hose is in the correct position. The
hose may be too low.
Make sure that the sink spigot is not clogged.
Make sure that the drain hose has no kinks or bends.
This problem may be caused by the clogged drain filter.
Please contact the Authorised Service Centre.
Make sure that the connection of the drain hose is correct.
Set the drain programme if you set a programme without
drain phase.
Set the drain programme if you set an option which ends
with water in the tub.
ENGLISH 19