Advertisement
Model 4440B
Section VI
Paragraphs 6-1 to 6-8
SECTION VI
MANUAL
CHANGES
AND OPTIONS
6-1.
OPTIONS
6-2.
Options are standard modifications
performed
on HP instruments
at the factory.
No options for the
Model 4440B are offered at the present time.
6-3,
SPECIAL
INSTRUMENTS
6-4.
"Specials" are standard HP instrument that are
modified according to customer specifications.
А
Separate insert sheet is included with the manual
for
Special instruments
having electrical changes.
Make
the changes specified in addition to any other changes
that are necessary.
6-5.
MANUAL
CHANGES
6-6.
This manual applies directly to the Model
4440B
with serials 935/936-00631 and above.
The following
paragraphs
explain how to adapt this manual to apply
to later
instruments
with
higher
serial
prefix,
or
earlier instruments with lower serial prefix.
Tech-
nical
corrections
to this manual
(if any) are called
errata andare listed ona separate" Manual
Changes"
sheet supplied with this manual,
6-7.
LATER INSTRUMENTS:
If the serial prefix of
your Model 4440B is above 935/936,
refer to a sepa-
rate "Manual Changes" sheet supplied with this manual.
Locate the serial prefix of your instrument and make
the indicated changes.
6-8.
EARLIER
INSTRUMENTS(Backdating Changes):
If the serial prefix of your Model 4440B is 935/936-
00630 and below,
refer to Table 6-1 for the changes
necessary
to adapt
this manual
to your
particular
instrument.
Locate the serial prefix of your
instru-
ment
in the table
and make
the
indicated
changes.
Note
that instrument
- component
values
that
differ
from
those inthis
manual,
yet are not listed in this
backdating changes, should be replaced using the part
number given in this manual.
Table 6-1.
Backdating Changes
Instrument
71
Serial Prefix or
Make Changes
Number
813/814
1,2,
3, 4, by 6; 1
815/816-00250 and
2, S 34
7
below
815/816-00370 and
3, 4, 5, 6, 7
below
919/920-00400 and
4, 5, 6, 7
below
935/936-00520 and
5, 6, 7
below
935/936-00630 and
6, Y
below
935/936 and below
"
CHANGE 1
Page 5-2,
Table 5-2, Reference Designation Index
Delete C18*,
C20*,
C22* and C24*
Page 7-3,
Figure 7-2, Schematic Diagram
Delete C18*,
C20*,
C22* and C24* from circuit.
CHANGE
2
Page 5-2,
Table 5-2, Reference Designation Index
Delete P/O J1 HP Part No.
04440-7048,
BINDING
POST ASS'Y:RED
Add P/O J1 HP Part No.
1510-0007,
BINDING POST:RED
CHANGE
3
Page 5-3,
Table 5-2, Reference Designation Index, Miscellaneous
Change HP PartNo.
of ANGLE:CAPACITOR
ASS'Y to 04440-1041.
4440 B-2
Advertisement
