Table of Contents
Advertisement
Cleaning
en
Cleaning the EasyClean filter
When ñ appears in the display panel,
clean the EasyClean filter as follows:
First clean the fluff filter ~ Page 27.
1.
Close the door of the dryer.
2.
Open the maintenance flap on the
3.
heat exchanger.
Release the levers on the EasyClean
4.
filter.
Use the grip handle to pull the
5.
EasyClean filter out.
Now take off the filter mat.
6.
Wash out the filter mat by hand
7.
using clean water.
Notes
– If the filter mat is covered with
stubborn dirt, you can also
remove this carefully using a
vacuum cleaner.
– Do not use cleaning agents.
Dry the filter mat by squeezing the
8.
water out.
Only use the filter mat if it is
Note:
clean and dry.
Put the filter mat back on.
9.
30
Ensure that the filter mat is
Note:
not misshapen, torn or clogged.
Position the filter mat as shown
above.
Check how dirty the dryer's heat
10.
exchanger is before putting the
EasyClean filter back in. If it is very
dirty, use a vacuum cleaner with a
brush attachment to clean it carefully
from top to bottom.
Take care not to bend or
Note:
damage the fins on the heat
exchanger when cleaning it.
Caution!
Risk of injury.
You could cut yourself on the fins of
the heat exchanger.
Do not touch these with your hands.
Slide the EasyClean filter in and
11.
make sure it clicks into place.
Close the maintenance flap.
12.
Switch the dryer off.
13.
You have now cleaned the EasyClean
filter.
If your filter mat is damaged, you
Note:
can order a new one from the after-
sales service using part number:
12007650.
Contact information for all countries can
be found on the enclosed after-sales
service list.
Advertisement
Table of Contents
