Noises; Cleaning; Cleaning The Dryer And The Control Panel; Cleaning The Moisture Sensor - Siemens WT45H209DN Installation And Operating Instructions Manual

Table of Contents

Advertisement

>

Noises

During drying, particularly in the
N ote:
N o i s e s
initial phase, operation of the appliance
results in noise from the compressor
and pump. This is perfectly normal and
does not impair proper functioning of
the appliance.
From time to time, the compressor in
the dryer generates a humming noise.
However, the volume may vary
depending on the programme and
progress of the drying process.
Every now and then, the compressor is
ventilated. This creates a whirring noise.
The condensation is pumped into
the condensate container by a pump.
This generates pumping noises.
D

Cleaning

C leaning the dryer and the
C l e a n i n g
control panel
:
Warning
Risk of death!
There is a risk of electric shock as the
dryer is operated with electricity.
Disconnect the dryer from the mains
before cleaning.
Clean the dryer using only water and a
soft, damp cloth.
Remove all detergent residue, spray
residue or other residues immediately.
Do not use cleaning agents or agents
for pre-treating laundry (e.g. prewash
sprays, stain removers). Do not use
high-pressure cleaners or steam jet
cleaners to clean your appliance.

Cleaning the moisture sensor

The dryer is equipped with a
Note:
stainless-steel moisture sensor. The
moisture sensor measures how damp
the laundry is.
After long periods of usage the moisture
sensor may become covered by a fine
layer of limescale or residues of
detergents and care products. Such
residues must be removed regularly as
the sensor function and in consequence
the drying result may be impaired.
Open the door and clean the moisture
sensor with a coarse sponge.
Caution!
Moisture sensor may be damaged.
Do not clean moisture sensors with
abrasives and steel wool.
Noises
en
29

Advertisement

Table of Contents
loading

This manual is also suitable for:

Wt43h2e8dn

Table of Contents