Solid-State Drive; Removing The Solid-State Drive - Dell NOT22108 Owner's Manual

Steps
1. Connect the battery cable to the system board, if the battery cable had been previously disconnected.
2. Align the screw holes on the base cover with the screw holes on the palm-rest and keyboard assembly, and then snap the
base cover into place.
3. Replace the six screws (M2x5) that secure the base cover to the palm-rest and keyboard assembly.
4. Tighten the four captive screws that secure the base cover to the palm-rest and keyboard assembly.
Next steps
1. Follow the procedure in

Solid-state drive

Removing the solid-state drive

Prerequisites
1. Follow the procedure in
2. Remove the base cover.
About this task
NOTE: Your computer has two M.2 solid-state drive slots, both located on the system board adjacent to the left fan. The
procedure to remove a solid-state drive from slot 1 and slot 2 are exactly the same.
NOTE: Depending on the configuration ordered, a 2230 or 2280 solid-state drive may be installed in your computer.
The following image(s) indicates the location of M.2 2230 solid-state drive or the M.2 2280 solid-state drive and provides a
visual representation of their respective removal procedures.
Removing the M.2 2230 solid-state drive
Removing the M.2 2280 solid-state drive
After working inside your
Before working inside your
computer.
computer.
Removing and installing Customer Replaceable Units (CRUs) 39