Table of Contents
Advertisement
AXYS
Intellivox ADC Installation Manual
®
corrEcTIoN EQ AND hIGh-PASS FIlTEr
Many building PA systems will include some provision for
equalisation (EQ) adjustment at the signal processing stage,
or within the power amplifier (as with the AXYS
PB-800 amplifiers). Adjusting EQ to achieve maximum system
intelligibility is a normal part of the commissioning process,
though it should be noted that measured intelligibility will
be greatly affected by several other factors not immediately
under the designer's control, such as reverberation time
and ambient noise levels. If external EQ adjustment is not
available, it may be desirable in some applications to modify
the frequency response of the loudspeaker itself.
The frequency response can be altered by means of two
switches labelled 'EQ' and 'HPF'. These switches are located
behind the inspection plate as indicated in fig.9.2 (Model
V90) and fig.9.3 (Model H90).
The EQ switch has two positions. The EQ is disabled if the
switch is in the 'Flat' position. The mid-cut EQ correction
is indicated in fig.10.1 (Model V90) respectively fig.10.3
(Model H90). The factory default setting is with EQ enabled
(flattest SPL versus frequency response). If the EQ is disabled
the maximum achievable SPL is somewhat higher, at the
expense of a SPL response that is less flat.
The HPF (high-pass filter) switch also has two positions.
The high-pass filter is disabled if the switch is in the 'Flat'
position. The frequency response of the high-pass filter
is indicated in fig.10.2 (Model V90) respectively fig.10.4
(Model H90). The filter response is slightly dependent on
the tap setting, the curves are valid for the 100 W tap. The
factory default setting is with the high-pass filter enabled,
this setting is most suitable for voice applications.
Note that the high-pass filter might have to be disabled in
case of 3rd-party line monitoring applications that make
use of a DC signal. DC will be blocked by a series capacitor
if the high-pass filter is enabled.
If the monitoring system uses an end-of-line unit, and DC
input to the loudspeaker should be blocked, the high-pass
filter should be enabled. If the monitoring system is to be
used in conjunction with the loudspeaker(s), without end-
of-line unit, the high-pass filter should be disabled.
201509/ADCIM
PB-400 and
®
SEcUrING ThE FroNT GrIll
option 1. After making the connections and setting the
power tapping, the front grill may be replaced. Do not
replace the protective foam! Align the four locating spigots
with the four larger holes in the back of the grill frame and
push the grill back on, ensuring that all four spigots locate
positively with the retaining clips within the holes.
option 2. The front grill may be secured more permanently
with the (supplied) M4 security screws. These need to be
fitted one at a time before replacing the grill.
Note that this does not apply to the integral load
monitoring of the AXYS
PB-400/PB-800 Industry
®
Amplifiers; these amplifiers do not use a DC signal
for load monitoring purposes.
19
Advertisement
Table of Contents
