Erasure Prevention - Technics SD-S947 Operating Instructions Manual

-_ source to be recording.
ing, and play the source to be
recorded.
L: I " I _ I _: TO begin recording from the forward
4: To begin recording from the reverse
side.
==
_IIIIIHHIIIIIDIIIIIIIIIIIHll
),,I.,,11...';,,-,_=.._,._
f3 n
0 u
I
Illuminates
m
When recording on both sides of the
tape, be sure to press the ), button.
To temporarily stop recording
• RECPAUSE
%
Press 9) REC PAUSE.
To resume recording
Press either < or _, corresponding to the side of
the tape side indicator which is lit.
= = u
I)111 innnlnnllll IIinllglll
.
Tape side indicator
About the selection of the Dolby NR type
The Dolby NR effect can be obtained by using the same type of
Dolby NR dudng both recording and playback. Refer to the follow-
ing table when selecting the type (either B or C).
Type B
TypeC
Use this type when the deck on which the tape will
be played back is equipped with only type B Dolby
NR.
Use this type when the deck on which the tape will
be played back is equipped with type C Dolby NR.
(for example, when this unit is also",going to be
used to p_y back the tape.)
Erasure prevention
Remove the tab(s).
Tab for side "B" break out the tab.
To re-record on a protected cassette
Cover the slotwith adhesive tape.
Attach tape.
To stop recording
%
Press II.
39-