Series Playback - Technics SD-S947 Operating Instructions Manual

Series playback
Both sides of the tape in Deck 1 will be played, followed by both
sides of the tape in Deck 2. (Repeated up to eight times.)
3412
I () () I
I
ocz:__
51-1-
m
Z
I I
,j
.I-15
nm
L..J L..J
J Preparation J
Load the tapes to be played into Deck I and Deck 2.
Note that for series playback it is not possible to select different
typesof DolbyNR forDeck 1 and Deck2. It is recommended that
you use two tapes which were recorded using the same type of
Dolby NR (or both recorded without Dolby NR).
y..R......... ...................................
Press DOLBY NR to select the
appropriate noise-reduction
system.
Press DOLBY NR to listen to
tapes recorded by Dolby B-
type noise-reduction.
'"R_ ........Pr_ss "REVERSEMO [)'Eto ...........
select the "CO" mode.
_] ....... D_cKi_ ......... F;re--"OeCK'__tosei_t_e ....
I _ JDeckl.
For your reference:
It is also possible to begin sedes playback from the reverse side of
the tape in Deck I or from Deck 2. (Refer to the tape travel table on
page 35.)
To stopplayback
Press II.
To temporarily stop playback
(Only available from the remote control.)
Press
II.
Press once again to resume playback.
-7 .................... ...................................................
_ (Series p_ck wi, begin from thefor-
X_ ward side of the tape in Deck 1.)