Table of Contents
Advertisement
DATE/CLOCK SETTING
The date and clock can be recorded on your tapes to act as a handy reference when viewing them at a later time.
Use the following procedure to set up this display for the current date and time.
"SHIFT" Button
"SET" Button
"DATE/TIME" Button
1. Load the camera/recorder's date/clock battery as
7. Press "SET" button to select year, and then press
described on page 8.
"SHIFT" button.
2. Slide the "*POWER"' switch to "САМ" while hold-
ing the small red button in the "POWER"
switch
down.
3. Place the power save lever to "NORMAL".
;
4. Press "DATE/TIME" button.
12; 00AM
Date and time appear in the viewfinder and "1"
11/ 5/91
flashes.
8. Press "SET" button as many times as may be re-
quired
to select
correct
hour,
and
then
press
"SHIFT" button.
9. Repeat steps 8 to select minute and AM/PM.
zi
: CCAM
/
1/90
5. Press "SET" button to select correct month.
Hold
button down to advance rapidly.
When the correct
S :30АМ
month appears, press "SHIFT" button.
6 923!
10. After setting AM
or PM, press "SHIFT"
button
again to erase the flashing cursor and start the
internal clock.
| | 2 ORAM
NOTE:
62429
* To
correct
date/clock
information
during
рго-
button down to advance rapidly.
When the correct
Then use "SET" button to enter the correct digit.
E20
Advertisement
Table of Contents
