Graco A Series Instructions-Parts List Manual page 5

RECOMMENDED INSTALLATION DATA FOR MODULAR
FLUID COMMANDER INVENTORY CONTROL SYSTEMS
(For fluids other than lubricants, contact Grace Application Engineering Department)
TYPE OF
SERVICE
LENGTH RECOMMENDED
*RECOMMENDED SIZE REQUIRED
OF RUN
PUMP SIZE &TYPE PLUMBING ADDITIONAL EQUIPMENT
Feet (Meters)
Motor Oil
And
Automatic
Transmission
Fluid
90 Gear Lube
140 Gear Lube
Air
SUPPlY
50 (15) maximum 1:l ratio 1 or2
100 (30) maximum 1 :l ratio 3 or 4
200 (60) maximum 5:l ratio
1 or2
Fluid supply line
200-500 (60-150) 5:l ratio 3 or 4 Pressure Relief Kit
500 (150) and over
1O:l ratio 1 or2
(No. 207-221 i
100 (30) maximum
5:l or 1O:l ratio 1 or2
200 (60) maximum
10: 1 ratio 3 or 4
50 (15) maximum
1O:l ratio 1 or2
100 (30) maximum
1O:l ratio 3 or 4
Compressor 5 RECOMMENDED EQUIPMENT
main lines
Master air valve (bleed type)
Stub lines
off main
6 Air control valve (204-886)
1. 5/8 in. OD annealed steel tubing of minimum 0.035 in. wall - use flareless fittings.
2. l/2 in. standard pipe -use heavy malleable iron fittings.
3. 7/8 in. OD annealed steel tubing of minimum 0.035 in. wall - use flareless fittings.
4. 3/4 in. standard pipe - use heavy malleable iron fittings.
5. l/2 in. OD type "L" soft copper tubing or l/2 in. galvanized pipe.
6. 3/8 in. or l/2 in. OD type "L" soft copper tubing or 3/8 in. or l/2 in. galvanized pipe.
307-362 5