Before You Start - Kenmore 625.385200 Use & Care Manual

Specifications & Performance Claims
continued from previous page
Variable Salt Dose: The salt dose is selected by the electronic controls at regeneration time based on the amount
needed.
Contaminant
Barium
Radium 226/228
Substance
Chlorine
= The water softener requires a minimum water flow of 3 gallons per minute at the inlet. Maximum allowable inlet
water pressure is 125 psi. If daytime pressure is over 80 psi, nighttime pressure may exceed the maximum. Use
a pressure reducing valve if necessary (Adding a pressure reducing valve may reduce the flow). Failure to use a
pressure reducing valve may cause damage to the system, resulting in flooding and damage to property. If your
home is equipped with a back flow preventer, an expansion tank must be installed in accordance with local codes
and laws.
= The water softener works on 24V DC electrical power, supplied by a direct plug-in power supply (included). Be
sure to use the included power supply and plug it into a nominal 120V, 60 Hz household outlet that is in a dry
location only, grounded and properly protected by an overcurrent device such as a circuit breaker or fuse.
= Do not use this system to treat water that is microbiologically unsafe or of unknown quality without adequate dis-
infection upstream or downstream of the system.
European Directive 2002/96/EC requires all electrical and electronic equipment to be disposed of accord-
ing to Waste Electrical and Electronic Equipment (WEEE) requirements. This directive or similar laws are
in place nationally and can vary from region to region. Please refer to your state and local laws for proper
disposal of this equipment.
Questions? Visit www.kenmorewatersolutions.com or call 1-800-695-2761.
PERFORMANCE CLAIMS
Influent Challenge Level
10 ±10% mg/L
25 pCi/L
Influent Challenge Level
2.0 ±10% mg/L

Before You Start

4
Maxiumum Allowable
Product Water Level
2.0 mg/L
5 pCi/L
Reduction Requirement
50%