Table of Contents
Advertisement
OWNER'S
MANUAL
MODEL NO.
625.384600
Caution:
Read and Follow
All Safety Rules,
Installation and
Operating
Instructions
Before First Use
of This Product.
If you have questions
when installing and us-
ing your drinking water
filter system,
call this
toll-free
number...
1 - 800 -426
- 9345
SAVE THIS MANUAL
UNDERSINK
DRINKING
WATER FILTER
SYSTEM
• Safety Guides
• Installation
• Operation
• Cartridge Replacement
• Repair Parts
!
System tested and certified
by NSF International
to
| /'Lm_r'_
ANSI/NSF
Standard
42 and 53 for the reduction
of
the claims specified
on the performance
data sheet.
Sears, Roebuck and Co., Hoffman Estates, IL 60179 USA
Advertisement
Table of Contents
Related Manuals for Kenmore 625.384600
Summary of Contents for Kenmore 625.384600
- Page 1 OWNER'S MANUAL MODEL NO. 625.384600 Caution: Read and Follow All Safety Rules, Installation and Operating Instructions Before First Use of This Product. If you have questions when installing and us- ing your drinking water filter system, call this toll-free number...
-
Page 2: Safety Guides
SAFETY GUIDES • Read all steps and guides carefully ling and using your undersink drinking system. Follow all steps exactly to correctly Reading this manual will also help benefits from undersink drinking system. • Do not use with water that is microbiologicaUy unsafe or of unknown quality... - Page 3 Parts of the System Materials Needed Drinking Water Filter System Installing Supply Installing Faucet Installing Filter Cartridge Using the Filtered Filter Cartridge Life / Replacement Repair Parts Locate the water filter housing on the cold water the cold drinking water. Refer to the following kitchen sink TABLE OF CONTENTS...
-
Page 4: Parts Of The System
PARTS OF THE SYSTEM filter system assembly including et and screws water supply fitting _" filtered water faucet for sink or countertop 3/8" tubing to make all needed TYPICAL FIG. 1 faucet filtered water supply fitting shutoff valve Note: To change the fil- ter cartridge, you must turn off the water and re- tease pressure by open-... -
Page 5: Installation
Check and comply with local plumbing fitting must provide a leak- tight connection cluded water supply fitting is shown (not included), is shown in B. A. WATER SUPPLY FITTING 1, Close the house main water open faucets to drain water from the sink cold water pipe. - Page 6 STEP 2 - MAKE HOLE FOR FILTERED WATER FAUCET Select I of the following places to install the faucet. sure there's room underneath so you can make needed connections. - - In an existing sink spray attachment - - Drill a hole in the sink top. - - Drill a hole in the countertop 1.
- Page 7 STEP 4 - MAKE TUBING CONNECTIONS 1. Allowing some slack, measure 3/8" tubing to connect between and the filter system inlet, FIG. 1. Cut the ends of the tubing square. 2. Insert tubing all the way into the supply inlet elbow fitting. Pull on the tubing it's held firmly...
-
Page 8: Using The System
Kenmore system model 625.384600 ment elements 42-34370 tested and certified by NSF International duction of protozoan cysts, lead and chlorine. - Page 9 FILTER CARTRIDGE CAUTION: Never remove sumps with water pres- sure in the filter system. 1. Close the water supply shut-off page 4) to the filter. Open the filtered to relieve pressure in the system. FIG. 6 seal TURN€ SUMP_ CLOCKWISE TO REMOVE 3.
-
Page 10: Repair Parts
Kenmore Undersink Drinking Water Filter System, Model No. 625,384600 REPAIR PARTS ___1... -
Page 11: Repair Parts List
REPAIR PARTS LIST ' KEY PART NUMBER 7160453 Screw, #10 - 14 x 3/4" (8 req.) 7182502 Mounting Bracket 9006053 Screw, #10 ~ 14 x 1-1/4" (2 req.) 7207881 Elbow, 3/8" NPT x 3/8" Tube (2 req.) 7156535 Head (2 req.) 7161255 Nipple, 3/8"... - Page 12 OWNERS MANUAL MODEL NO. 625,384600 model number your drinking water filter system is found on the rating decal, mounting bracket. When requesting service or ordering parts, always provide the following in- formation: • Product Type • Model Number • Part Number •...