Advertisement
3-3.
IDLING CURRENT ADJUSTMENT
Connect the DC voltmeter between T.P-1 and T.P-2.
. Adjust R139 (BX-500) or R130 (BX-300) so that the DC voltmeter indicates approx. 100 mV.
. After R139 (BX-500) or R130 (BX-300) adjusted, wait/30 seconds for idling.
. Connect the DC voltmeter between T.P-3 and T.P-4.
Repeat procedures 1 to 4 above and adjust R239 (BX-500) or R230 (BX-300).
1.
2
3
4. Readjust R139 (BX-500) or R130 (BX-300) so that the DC voltmeter indicates 26 mV +15 mV.
5
6.
N
| BX-500/BX-300
OTE: When using an oscilloscope, instead of the DC voltmeter, carefully connect the oscilloscope so that the oscilloscope GND terminal is
not connected to the GND of the amplifier, thereby causing a short. Use the oscilloscope in the floating state.
DC VOLTMETER
100 mv
26 mV
i
L
3-4
POWER OUTPUT METER ADJUSTMENT (BX-500 only)
1. Connect the AC voltmeter to the SPEAKERS A terminal.
. Set the VOLUME control to MAX.
oO
PF Wh
NOTE: BX-500 should be placed in the normal operating position.
3-5
VOLTAGE CONVERSION
(GENERAL EXPORT MODEL ONLY)
BE SURE TO
REMOVE THE POWER
CORD
FROM THE AC
OUTLET
BEFORE
REMOVING
THE OUTER
CASE AND
RE-
POSITIONING THE VOLTAGE CONVERSION PLUG.
1. Remove the top and side metal cover by removing screws in each
side of the metal cover.
2. Locate the woltage selector plug on the left side of the BX-500,
BX-300.
3. Remove the plug by pulling it out and re-install it so that the
arrow on the plug exactly lines up with the white line that
in-
dicates the appropriate voltage.
4. Replace the top cover.
R139(R130)
. Set the SPEAKERS selector to A and SOURCE selector to AUX.
117V
lOOV
TA- 065
Advertisement
