Table of Contents
Advertisement
Problem
Possible cause Remedy/information
Power cut
0
and zeros
light up in the
display.
The oven does
There is dust on
not heat up.
the contacts.
The oven door
The oven door
cannot be
is locked by
opened. The
L
self-cleaning.
symbol lights
up in the dis-
play.
The oven does
The oven is in
not heat up. The
demonstration
colon in the dis-
mode.
play flashes.
F8 appears in
Automatic
the display.
switch-off has
been activated.
Error messages
If an error message with
"
reset the clock. If the error message appears again, call the
after-sales service.
You can take remedial action yourself if the following error
messages are displayed.
Error message Possible cause Remedy/information
A button was
"‹‚‚
depressed for
too long or is
covered up.
The tempera-
"‚‚†
ture in the cook-
ing
compartment is
too high.
After-sales service
Our after-sales service is there for you if your appliance needs
to be repaired. We will always find the right solution in order to
avoid unnecessary visits from a service technician.
E number and FD number
When calling us, please give the product number (E no.) and
the production number (FD no.) so that we can provide you with
the correct advice. The rating plate containing these numbers
can be found on the right-hand side of the oven door. You can
make a note of the numbers of your appliance and the
telephone number of the after-sales service in the space below
to save time should it be required.
E no.
O
After-sales service
Reset the clock.
Turn the control knobs back
and forth several times.
Wait until the oven has
q
cooled down and the
symbol goes out.
Switch off the circuit
breaker in the fuse box and
switch it on again after
approximately 20 seconds.
Now, within approx.
2 minutes, press and hold
the
D
button for approx.
4 seconds until the colon
lights up constinuously.
Turn the function selector to
the off position.
appears, press the
button. Then
0
Press all buttons individu-
ally. Check whether any but-
tons are jammed, covered
up or soiled.
The oven door locks and
heating is suspended. Wait
until the oven has cooled
down. Press the
0
and reset the clock.
FD no.
:
Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be carried
out by one of our trained after-sales engineers.
Replacing the bulb in the oven ceiling light
If the bulb in the oven light fails, it must be replaced. Heat-
resistant, 40 watt spare bulbs can be obtained from our after-
sales service or a specialist retailer. Only use these bulbs.
L
:
Risk of electric shock!
Switch off the circuit breaker in the fuse box.
Place a tea towel in the oven when it is cold to prevent
1.
damage.
Remove the glass cover. To do this, press back the metal
2.
tabs with your thumb (Fig. A).
Unscrew the bulb and replace it with one of the same type
3.
(Fig. B).
Refit the glass cover. When doing this, insert it on one side
4.
and press firmly on the other side. The glass cover will click
into place.
Remove the tea towel and switch on the circuit breaker.
5.
Glass cover
You must replace a damaged glass cover. Suitable glass
covers may be obtained from the after-sales service. Please
specify the E number and FD number of your appliance.
button
Please note that there will be a fee for a visit by a service
technician in the event of a malfunction, even during the
warranty period.
Please find the contact data of all countries in the enclosed
customer service list.
To book an engineer visit and product advice
0344 892 8979
GB
Calls charged at local or mobile rate.
01450 2655
IE
0.03 € per minute at peak. Off peak 0.0088 € per
minute.
Rely on the professionalism of the manufacturer. You can
therefore be sure that the repair is carried out by trained service
technicians who carry original spare parts for your appliances.
17
Advertisement
Table of Contents
