Dell D30M Setup And Specifications page 29

NOTE: High-speed drives spin the disc at a high rotational speed. If a disc has printing on
only half of the disc, or if there is a slight imbalance in the disc, the imbalance is greatly
magnified by the high speed, causing the drive to vibrate or produce a fan-like noise. These
effects are inherent in the high-speed technology and do not indicate a problem with the
drive.
Emergency Eject
The procedure described below can be used to remove a disc from the drive if the eject button is
disabled by software or if a power failure occurs.
1. Turn the computer off.
2. Insert a small diameter rod or a stiff wire (a straightened paper clip about 1.2 mm [0.047
in] in diameter) into the emergency eject hole and push firmly.
3. The disc tray is ejected by about 10 mm (0.39 in). Pull the disc tray out.
NOTE: Do not insert more than 50 mm (1.9 in) in depth.
Inserting more than 50 mm (1.9 in) may damage the drive.
Cleaning Media
•· If dust or fingerprints get on the disc, wipe it with a soft cloth from the center to the edge.
CAUTION: Do not use benzene, paint thinner, record cleaner, solvent or static
repellent. This can damage the disc.