LG TWC1409H3E Owner's Manual page 45

Symptoms
Dry problem Check water supply tap.
This odor is caused by the rubber
attached to the washing machine.
If the rubber door gasket and door
seal area are not cleaned regularly,
odors can occur from mold or
foreign substances.
Odors can occur if foreign
substances are left in the drainage
pump filter.
Odors can occur if the drainage
Odor
hose is not properly installed,
causing siphoning (water flowing
back inside the washing machine).
Using the dry function, odors can
occur from lint and other laundry
matter sticking to the heater. (Dryer
model only)
A particular odor can occur from
drying wet clothes with hot air.
(Dryer model only)
The password for the Wi-Fi that you
are trying to connect to is incorrect.
Mobile data for your smartphone is
turned on.
The wireless network name (SSID)
Your home
is set incorrectly.
appliance and
smartphone is
not connected to
the Wi-Fi The router frequency is not 2.4
network.
GHz.
The distance between the appliance
and the router is too far.
Reason Solution
• Do not overload. Check that the
washing machine is draining properly
to extract adequate water from the
load. Clothes load is too small to
tumble properly. Add a few towels.
• Turn off water supply tap.
• It is the normal odor of new rubber
and will disappear after the machine
has been run a few times.
• Be sure to clean the gasket and door
seal regularly and check under the
door seal for small items when
unloading the washer.
• Be sure to clean the drainage pump
filter regularly.
• When installing the drainage hose,
be sure that it doesn't become
kinked or blocked.
• This is not a malfunction.
• The odor will disappear after a short
while.
• Find the Wi-Fi network connected to
your smartphone and remove it, then
register your appliance on LG
SmartThinQ.
• Turn off the Mobile data of your
smartphone and register the
appliance using the Wi-Fi network.
• The wireless network name (SSID)
should be a combination of English
letters and numbers. (Do not use
special characters.)
• Only a 2.4 GHz router frequency is
supported. Set the wireless router to
2.4 GHz and connect the appliance
to the wireless router. To check the
router frequency, check with your
Internet service provider or the router
manufacturer.
• If the distance between the
appliance and the router is too far,
the signal may be weak and the
connection may not be configured
correctly. Move the location of the
router so that it is closer to the
appliance.
EN
45