Table of Contents
Advertisement
4. If the "Please click [OK] to run the TOSHIBA Cooling
Performance Diagnostic Tool to check the cooling
performance of your PC." message is still displayed after running
the "TOSHIBA Cooling Performance Diagnostic Tool" in step 3, it is
recommended you turn off the computer and contact TOSHIBA support.
Cleaning the cooling module
This section explains how to clean the cooling module.
If you use the computer for a long period, the inside of the computer may
become hot. Always allow the computer to cool to room temperature
before you clean the cooling module.
To clean the cooling module, follow the steps detailed below:
1. Shut down the computer - make sure the Power indicator is off (refer to
the
required).
2. Remove the AC adaptor and all cables and peripherals connected to
the computer.
3. Close the display panel and turn the computer upside down.
4. Remove the battery pack (refer to the
section in Chapter 6,
5. Loosen the one screw securing the Cooling module cover.
Use a point size 0 Phillips screwdriver.
6. Slide your fingernail or a thin object under the cover and lift it off.
User's Manual
Turning off the power
Power and Power-Up
Figure G-1 Removing the cooling module cover
section in Chapter 1,
Replacing the battery pack
Modes, if required).
Cooling module cover
TECRA R10
Getting
Started, if
Screw
G-3
Advertisement
Table of Contents
