Braun 8590 Manual page 12

12
Description
1. Low-voltage adapter
2. «start cleaning» button
3. Station-to-shaver connecting contacts
4. Station lift button for cartridge exchange
5. Display for cleaning programs
6. Display for cleaning fluid status
7. Station mains socket
8. Cleaning cartridge
9. Shaver foil protection cap
10. Shaver foil
11. Cutter block
12. Foil release buttons
13. Long hair trimmer
14. Shaver-to-station connecting contacts
(shaver backside)
15. Switch
16. Shaver charging lights (green)
17. Shaver low-charge light (red)
18. Pilot light
19. Shaver mains socket
Before shaving
If you wish, you may start shaving right away (if the shaver
is charged, see section «Shaver indicator lights»).
However, we recommend to follow the procedure
described here:
• Using the low-voltage adapter (1), connect the mains
socket of the Clean&Charge station (7) to the mains.
• Press the station lift button (4) to open the housing.
1
• Hold the cleaning cartridge (8) down on a flat, stable
surface (e.g. table).
• Carefully remove the lid from the cartridge.
• Slide the cartridge into the base of the station as far as
it will go.
• Slowly close the housing by pushing it down until it
locks.