Panasonic CF-50 Series Operating Instructions Manual page 29

Shutting down
Windows cannot be shut
down or restarted
Battery Indicator
The red indicator lights
The red indicator blinks
The green indicator
blinks
The orange indicator
blinks
Reference Manual
The Reference Manual is
not displayed
Fast User Switching function
Some applications do
not work properly
Others
No response
If a USB device is connected, try removing it.
The battery level is very low (the charge is approx. 9% or less).
Connect the AC adaptor. You can use the computer when the indicator light is
orange. If you do not have an AC adaptor, save your data and power off your
computer. After replacing the battery pack with a fully charged one, turn your
computer on.
Quickly save your data and power off your computer. Remove the battery pack and
disconnect the AC adaptor, then connect them again.
If the problem persists, contact Panasonic Technical Support (
battery pack or charging circuit may be defective.
In high temperature mode, the battery pack is discharging to a level of 80%
mal temperature mode.(⇒Reference Manual "Battery Power") Do not remove the
battery pack while the battery indicator is blinking green.
*1
A level of 80% in normal temperature mode is displayed as [100%] in high temperature mode.
Battery cannot be recharged temporarily because the internal temperature of the
battery pack is outside of the acceptable temperature range for recharging. Once
the allowable range requirement is satisfied, charging begins automatically. Your
computer can be used normally in this state.
Is Acrobat Reader installed?
If Acrobat Reader is not installed, run [c:\util\reader\acroreader51_enu_full.exe] in
[start] - [Run] to reinstall the program. When installing the program, do not change
the installation destination folder. If the destination folder is changed, the Reference
Manual cannot be opened from [start] menu.
When switching to a different user with the Fast User Switching function, the follow-
ing problems may occur.
• Some applications may not work properly.
• Key combination with Fn may not work.
• It may not be possible to set the settings of the display.
• The wireless LAN cannot be used.
• A serial mouse may not work.
• The B's CLiP icon will no longer be shown on the taskbar and and B's CLiP cannot
be used.
In this case, log off all users without using Fast User Switching function, and try the
operation once more. If the problem persists, restart the computer.
Press Ctrl+Shift+Esc to open Task Manager and close the software application
which is not responding.
After shutting down by pressing the power switch for more than four seconds, press
the power switch to power on and open the application again.
If the program no longer works normally, delete the program using the following
procedure. Then reinstall the program.
[start] - [Control Panel] - [Add or Remove Programs]
page 38). The
*1
in nor-
29