Operating Instructions - Stihl KM 91 R Instruction Manual

position F. After a cold start, warm
up the engine by opening the
throttle several times.
WARNING
There is a risk of injury if the KombiTool
runs when the engine is idling. Adjust
the carburetor so that the KombiTool
does not run when the engine is idling –
see "Adjusting the Carburetor".
Your machine is now ready for
operation.
Stopping the Engine
Depress the momentary contact
N
stop switch – the engine stops –
release the stop switch – it springs
back to the run position.
Other Hints on Starting
Engine stalls in cold start position g or
under acceleration.
Move the choke knob to < and
N
continue cranking until the engine
runs.
Engine does not start in warm start
position <
Move the choke knob to g and
N
continue cranking until the engine
runs.
If the engine does not start
Check that all settings are correct.
N
Check that there is fuel in the tank
N
and refuel if necessary.
KM 91 R
Check that the spark plug boot is
N
properly connected.
Repeat the starting procedure.
N
Engine is flooded
Move the choke knob to F and
N
continue cranking until the engine
runs.
Fuel tank run until completely dry
After refueling, press the manual
N
fuel pump bulb at least five times –
even if the bulb is already filled with
fuel.
Set the choke lever to suit the
N
engine temperature.
Now start the engine.
N

Operating Instructions

During break-in period
A factory-new machine should not be
run at high revs (full throttle off load) for
the first three tank fillings. This avoids
unnecessary high loads during the
break-in period. As all moving parts
have to bed in during the break-in
period, the frictional resistances in the
engine are greater during this period.
The engine develops its maximum
power after about 5 to 15 tank fillings.
During Operation
After a long period of full throttle
operation, allow the engine to run for a
short while at idle speed so that engine
heat can be dissipated by the flow of
cooling air. This protects engine-
mounted components (ignition,
carburetor) from thermal overload.
After Finishing Work
Storing for a short period: Wait for the
engine to cool down. Empty the fuel tank
and keep the machine in a dry place,
well away from sources of ignition, until
you need it again. For longer out-of-
service periods – see "Storing the
Machine".
English
13