Connecting To The In-Circuit Simulator; Disabling The Target-System Interface; Mon08 Target System Connector Layout; Mon08 Target System Connector P2 - Motorola M68LC302CAF20VCT User Manual

Pin M68ICS08RK2
No. Label
1 RST

4.4 Connecting to the In-Circuit Simulator

4.5 Disabling the Target-System Interface

M68ICS08RK In-Circuit Simulator — Rev. 1
MOTOROLA
Table 4-2. MON08 Target System Connector P2
Direction
Connect to MCU RST pin and P2 pin 4. No other target system
Bidirectional
logic should be tied to this signal. It will swing from 0 to +7.5 Vdc.
Figure 4-1. MON08 Target System Connector Layout
Using the 16-pin cable provided with the RKICS kit, connect one end of the
cable to the RKICS board at J2. Connect the other end to connector P1 on the
target-system board. The pin-1 indicators on each cable end must correspond to
the pin-1 indicators on the headers. P2 is not used when connecting to the
RKICS board.
To use the target system in a stand-alone fashion (without the RKICS board
connected), jumper the pins on the target board's connectors, as shown in
Figure 4-2. This reconnects the target MCU to the appropriate circuits on the
target system.
Using the MON08 Interface
Using the MON08 Interface

Connecting to the In-Circuit Simulator

Target System Connection
1
2
P2
15 16
P1
User's Manual
47