Installing The Hardware; Installing The Software - Motorola M68LC302CAF20VCT User Manual

Hardware Installation

2.4 Installing the Hardware

2.5 Installing the Software

User's Manual
32
For installing Motorola development tools, the following steps provide
installation instructions for the RKICS hardware.
Before beginning, locate these items:
• 9-pin RS-232 serial connector on the board, labeled P2
• 5-volt circular power-input connector on the RKICS
To prepare the RKICS for use with a host PC:
1. Install the MCU into the M68ICS08RK2 board.
Locate the appropriate socket on the board:
– For SSOP, locate XU1
– For SOIC, locate XU2
– For QFP, locate XU3
Install the MCU (provided with the RKICS package) into this socket,
observing the pin 1 orientation with the silkscreened dot. The top
(label side) of the MCU package must be visible when looking at the
component side of the board.
2. Connect the board to the host PC.
Locate the 9-pin connector labeled P2 on the board. Using the cable
provided, connect it to a serial COM port on the host PC.
3. Apply power to the board.
Connect the 5-volt power supply to the round connector on the board.
Plug the power supply into an ac power outlet, using one of the
country-specific adapters provided. The ICS power LED on the board
should light.
For instructions for installing the ICS08 software, refer to P&E Microcomputer
Systems, Inc., M68ICS08 68HC08 In-Circuit Simulator Operator's Manual,
Motorola document order number M68ICS08OM/D.
Hardware Installation
M68ICS08RK In-Circuit Simulator — Rev. 1
MOTOROLA