Table of Contents
Advertisement
Available languages
Available languages
Level Washer/Dryer
IMPORTANT:
Level washer/dryer
properly to reduce excess
noise and vibration.
1.
Check
levelness
of washer/dryer
L
level here
With washer/dryer
in its final location, place a level on top
edges of washer/dryer.
Use side seam as a guide to check
levelness of sides. Check levelness of front using lid, as
shown. Rock washer/dryer
back and forth to make sure all
four feet make solid contact with floor. If washer/dryer
is level,
skip to step 3 (27" models) or step 4 (24" models).
Not Level
LEVEL
Not Level
2.
Adjust leveling
feet (27" model
shown)
When washer/dryer
is level, use a 9/16" or 14 mm open-end
or adjustable wrench to turn jam nuts counterclockwise
on
leveling feet tightly against washer/dryer
cabinet.
HELPFUL TIP: You may want to prop washer/dryer
with
a wooden block.
4.
Fasten washer/dryer
to floor
(if needed)
For mobile home use: Washer/dryers
with gas dryers must
be securely fastened to the floor.
Mobile home installations require a Mobile Home Installation
Kit. See "Tools and Parts" section for information
on ordering.
If washer/dryer is not level, prop up front of washer/dryer
about 4" (102 mm) with a wood block or similar object that
will support weight of washer/dryer.
On 27" models, use a 9/16" or 14 mm open-end or adjustable
wrench to turn jam nuts clockwise on feet until they are
about 1/2" (13 mm) from the washer/dryer
cabinet. Then
turn the leveling foot clockwise to lower the washer/dryer
or counterclockwise
to raise the washer/dryer.
On 24" models, adjust the feet up or down as necessary.
On all models, remove wood block and lower washer/dryer.
Recheck levelness of washer/dryer
and repeat as needed.
22
Advertisement
Table of Contents
