Table of Contents
Advertisement
20
www.aeg.com
The led of the button is on and the
display shows the set programme
duration.
This option can also be used
to shorten the steam mode
duration.
7.10 Temperature
When you select a washing programme,
the appliance automatically proposes a
default temperature.
Touch this button repeatedly until the
desired temperature value appears on
the display.
When the display shows the indicators
and
the water.
7.11 Spin
When you set a programme, the
appliance automatically selects the
default spin speed.
Touch this button repeatedly to:
• Change the spin speed.
The display shows only
the spin speeds available
for the set programme.
• Activate the Rinse Hold option .
The water of the last rinse is not
drained out to prevent the fabrics from
creasing. The washing programme
ends with water in the drum and the
final spin phase is not performed.
The display shows the indicator
The drum turns regularly to reduce
creasing.
The door stays locked. The drum
turns regularly to reduce creasing.
You must drain the water to unlock
the door.
Touch Start/Pause button
appliance performs the spinning
phase and drains the water.
• Activate the Extra silent option.
All spinning phases (intermediate spin
and final spin) are suppressed and
the programme ends with water in the
drum. This helps to reduce creasing.
As the programme is very quiet, it is
suitable for use at night time when
, the appliance does not heat
cheaper electricity tariffs are
available. In some programmes the
rinses are performed with more water.
The display shows the indicator
The door stays locked. The drum
turns regularly to reduce creasing.
You must drain the water to unlock
the door.
Touch the Start/Pause button: the
appliance performs only the draining
phase.
• No Spin
Set this option to deactivate all spin
phases. The display shows the
indicator
performs the only draining phase of
the selected washing programme. Set
this option for very delicate fabrics.
The rinses phase uses more water for
some washing programmes
7.12 Stains/Prewash
Press this button repeatedly to activate
one of the two options.
The relevant indicator goes on in the
display.
• Stains
Select this option to add an anti-stain
phase to a programme in order to
treat heavily soiled or stained laundry
with stain remover.
Pour the stain remover into
.
compartment
will be added in the appropriate phase
of the washing programme.
: the
• Prewash
Use this option to add a pre-wash
phase at 30 °C before the washing
phase.
This option is recommended for
heavily soiled laundry, especially if
containing sand, dust , mud and other
solid particles.
.
. The appliance
The appliance empties the
water out automatically after
approximately 18 hours.
. The stain remover
This option is not
available with a
temperature lower than
40 °C.
.
Advertisement
Table of Contents
