iRobot Roomba Combo i5+ Owner's Manual page 28

Regulatory Information
FCC Supplier's Declaration of Conformity
iRobot Corporation Roomba Model: RVD-Yl, ADJ-Nl
Contains FCC ID: UFE-AXFYl and contains IC: 6652A-AXFY1
This device complies with part l 5 of the FCC Rules and CAN ICES-003(8) /
NMB-003(8).
Operation is subject to the following two conditions:
(l) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference
that may cause undesired operation.
This device complies with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions:
( l) This device may not cause interference, and
(2) This device must accept any interference, including interference that may
cause undesired operation of the device.
• Changes or modifications not expressly approved by iRobot Corporation
could void the user's authority to operate the equipment.
• This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules as well as ICES-
003 Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference to radio
communication will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
• Under Industry Canada regulations, this radio transmitter may only operate
using an antenna of a type and maximum (or lesser) gain approved for
the transmitter by Industry Canada. To reduce potential radio interference
to other users, the antenna type and its gain should be so chosen that
the equivalent isotropically radiated power (e.i.r.p.) is not more than the
necessary for successful communication.
• FCC Radiation Exposure Statement: This product complies with FCC
§2. l 091 (b) for mobile device RF exposure limits, set forth for an uncontrolled
environment and is safe for the intended operation as described in this
manual. Per FCC requirements, maintain a distance of more than 8 inches
(20 cm) between any person and the host device (Roomba robot).
• ISED Radiation Exposure Statement: This product complies with the Canadian
Standard RSS-1 02 for mobile device RF exposure limits, set forth for an
uncontrolled environment and is safe for the intended operation as described
in this manual. Per ISED requirements, maintain a distance of more than 8
inches (20 cm) between any person and the robot.
iRobot Corporation, 8 Crosby Drive, Bedford, MA 01730 USA.
http://global.irobot.com
For battery recycling go to call2recycle.org;
or call l -800-822-8837
Roomba• i5+ Safety Guide 5