Table of Contents
Advertisement
7.2
Power Supply
Refer to figure
Figure 7-2
platform.
CN8601(FOR 715G6679P)
CN8101(FOR 715G715G6677P/715G6973P)
Display power
PFC
7.2.1
Power Supply Unit
All power supplies are a black box for Service. When defective,
a new board must be ordered and the defective one must be
returned, unless the main fuse of the board is broken. Always
replace a defective fuse with one with the correct
specifications! This part is available in the regular market.
Consult the Philips Service web portal for the order codes of the
boards.
Important delta's with the TPM16.1HE LA classis platform are:
•
New power architecture for LED backlight
•
"Boost"-signal is now a PWM-signal + continuous variable.
The control signals are:
•
Stand-by
•
Lamp "on/off"
•
DIM (PWM) (not for PSDL)
In this manual, no detailed information is available because of
design protection issues.
The output voltages to the chassis are:
•
+3.5V output (standby mode) for 43''
+3.65V output (standby mode) for 49''/55''
•
+12 output (on-mode)
•
+12V_audio (audio AMP power)
for the power architecture of this
Ac-input + Mains filter
Figure 7-2 Power Architecture
Connector
Number
CN9101
CN8601
Description
to SSB
to panel
Pin
16
12
1
DIM
+VLED
2
BL_on/off
n.c.
3
PS_ON
-VLED1
Circuit Descriptions
Platform power
BL-ON/OFF
DIM
PS_On
12V
12V_A
Low stby
power
AC IN
CN9901
•
Output to the display; in case of
- IPB: High voltage to the LCD panel
- PSL and PSLS (LED-driver outputs)
- PSDL (high frequent) AC-current.
7.2.2
Diversity
The diversity in power supply units is mainly determined by the
diversity in displays.
The following displays can be distinguished:
•
CCFL/EEFL backlight: power panel is conventional IPB
•
LED backlight:
- side-view LED without scanning: PSL power panel
- side-view LED with scanning: PSLS power panel
- direct-view LED without 2D-dimming: PSL power panel
- direct-view LED with 2D-dimming: PSDL power panel.
PSL stands for Power Supply with integrated LED-drivers.
PSLS stands for a Power Supply with integrated LED-drivers
with added Scanning functionality (added microcontroller).
PSDL stands for a Power Supply for Direct-view LED backlight
with 2D-dimming.
7.2.3
Connector overview
Table 7-1 Connector overview
CN9101
CN8101
to SSB
to panel
16
12
DIM
+VLED
BL_on/off
n.c.
PS_ON
-VLED1
back to
div.table
TPM16.1HE LA
AMP
12V
Platform
MT5593F
CN700
1 power- PCB
CN9101
CN8101
to SSB
to panel
16
12
DIM
+VLED
BL_on/off
n.c.
PS_ON
-VLED1
7.
EN 27
LVDS AMP
12V
20120_201.eps
2016-May-13
Advertisement
Table of Contents
