Side-Discharging The Clippings; Operating Tips - Toro eTimeMaster 21491 Operator's Manual

Side-Discharging the Clippings

Use the side discharge for cutting very tall grass.
If the bag is on the machine, remove it and insert the rear-discharge plug; refer to
(page 16) before side-discharging the clippings.
Important:
Ensure that the rear-discharge plug is in place before you recycle the clippings
Installing the Side-Discharge Chute
1. Remove the side-discharge deflector bracket and fasteners (A of
2. Lift open the side-discharge deflector (B of
3. Install the side-discharge chute and close the deflector onto the chute (C and D of
1. Locknut
2. Bolt
Removing the Side-Discharge Chute
To remove the side-discharge chute, reverse the steps in
Important:
Install the deflector bracket when not using the side-discharge chute (A of

Operating Tips

General Mowing Tips
•
Inspect the area where you will use the machine
and remove all objects that the machine could
throw.
•
Avoid striking solid objects with the blades. Never
deliberately mow over any object.
•
If the machine strikes an object or starts to vibrate,
immediately shut off the machine, wait for all
moving parts to stop, remove the battery pack
Figure
Figure 19).
Figure 19
3. Deflector bracket
Installing the Side-Discharge Chute (page
from the machine, and examine the machine for
damage.
•
For best performance, install new Toro blades
before the cutting season begins or when
necessary.
Cutting Grass
•
Cut only about a third of the grass blade at a time.
For improved quality of cut, runtime, and bagging,
cut grass at a higher height of cut.
17
Removing the Grass Bag
(Figure
19).
Figure 19).
17).
Figure
17).
g443824
19).